Table of Contents
Advertisement
Troubleshooting the Service
Keyword/Variable
Description
ip_pool_name
The name of the IP pool configured for IPsec Tunnel.
numeric characters in length and is case sensitive.
des_ip_address
The IP address of destination node of IPsec tunnel.
src_ip_address
The IP address of source node of IPsec tunnel.
Using the SNMP TRAP command for debugging
Once the thresholds are configured, then notifications get generated on reaching the limit in the configured interval and
are then shown in the SNMP trap.
The SNMP traps for HeNB-GE service can be configured using the following command syntax:
snmp trap enable { ThreshHENBGWHenbSessions | ThreshHENBGWPagingMessages |
ThreshHENBGWUeSessions } target trap_target
Keyword/Variable
ThreshHENBGWHenbSessions
ThreshHENBGWPagingMessages
ThreshHENBGWUeSessions
trap_target
Using the RESOURCES SESSION command for debugging
The
show resources session
subscribers/UEsconnecting to the HeNB-GW.
The license status for all sort of resources can be viewed using the following command syntax:
show resources session
In case, the number of sessions are within the acceptable limits, the output of the above command looks as the following
sample (only HeNB-GW related sessions have been shown):
HENBGW Service:
In Use : 1161
Max Used : 1161 ( Monday May 06 05:22:00 IST 2013 )
Limit : 2000
License Status : Within Acceptable Limits
HENBGW UE Service:
Description
Enables the threshold configuration for HeNB-GW HeNB sessions.
Enables the threshold configuration for HeNB-GW paging messages.
Enables the threshold configuration for HeNB-GW UE sessions.
Specifies that these trap(s) should be sent to this trap target.
command is ideal for debugging the license-controlled number of HeNBs and
can be from 1 to 63 alpha and/or
ip_pool_name
Cisco ASR 5x00 Home eNodeB Gateway Administration Guide ▄
Test Commands ▀
61
Advertisement
Table of Contents
Troubleshooting
