Advertisement
Quick Links
Installati
instructions
Built-ln
Wall Oven
27" (68.6 cm) models
JKSI0,
JKP30, JKP35, JKP55, JKP70, JKP75,
PK916, PK956, ZEK938,
ZEK958
30" (76.2 cm) models
JTP30, JTP35, JTP55, JTP70, JTP75, PT916,
PT920, PT956, PT960, ZET938,
ZET958
if you have questions,
call 1.800.GE.CARES
or visit our website
at:
ge.com
Before You Begi n
• Proper
installation
is the
responsibility
of the installer
and product
failure
due
Read these instructions carefully and completely.
• IMPORTANT-save these
instructions
for local inspector's
use.
• IMPORTANT-obse_,e all
governing
codes
and ordinances.
• Note to InstallermBe
sure to leave these
instructions
with the consumer.
• Note to ConsumermKeep
these
instructions
for future
reference.
to improper
installation
is NOT covered
under warranty.
NOTE=This
appliance
must be properly
grounded.
ATTENTION INSTALLER
All electric wall ovens
must be hard wired
(direct
wired) into an approved
junction
box. A plug and receptacle
is NOT permitted
on these products.
Parts Included
(Appearance
will vary)
Screws For Installation
(8-18 x .750 flat head
Phillips wood screws)
27" (68.6 cm)
Metal Bottom Trim
(68.6 cm)
Metal Bottom
Trim Assembly
(on some models or
can be purchased
separately)
30" (76.2 cm)
Metal Bottom Trim
Assembly
Materials Needed
__
_
WireNu_ts
Strain Relief Clamp
Junction
for 1/2" conduit
Box
_k_
_
36" (91 cm)
of String
Tools Needed
1/8" (3 mm) Drill Bit and
Electric or Hand Drill
Phillips
Screwdriver
31-10647-2
07-07 JR
Advertisement
Related Manuals for GE Built-ln Wall Oven
Summary of Contents for GE Built-ln Wall Oven
- Page 1 PK916, PK956, ZEK938, ZEK958 instructions 30" (76.2 cm) models JTP30, JTP35, JTP55, JTP70, JTP75, PT916, PT920, PT956, PT960, ZET938, ZET958 if you have questions, call 1.800.GE.CARES or visit our website ge.com Before You Begi n installation is the • Proper responsibility...
-
Page 2: Important Safety Instructions
Installation Instructions IMPORTANT SAFETY INSTRUCTIONS Electrical For Your Safety Requirements • Be sure your oven is installed properly cont. a qualified installer or service technician. • Be sure the oven is securely installed in a Rating plate is located on oven side trim, side front frame or lower front frame. - Page 3 Installation Instructions Pre-lnstallation Checklist Door removal is not a requirement ALL INSTALLATION INFORMATION installation of the product, but is an added convenience. To remove the door: ON THE FOLLOWING PAGES IS TO BE USED FOR SINGLEAND DOUBLE OVEN INSTALLATION! Open the oven door as far as it will go. Remove packaging materials.
- Page 4 Installation instructions uilt-ln Cutou for 27"(68.6 ngle Ovens only For JKS10, JKP30, JKP70, PK916, ZEK938 models only. Cabinet Width 27" (68.6 cm) 5" (12.7 cm) Max. from the Recommended left or right Cutout Location Cabinet_ Junction Location from Floor 32 1/2" (82.6 cm) 27"...
- Page 5 Installation instructions Cutoutfor 27"(68.6 DoubleBuilt-in Ovensonly For JKP35, JKP55, JKP75, PK956, ZEK958 models only. 6" (12.7 cm) Cabinet Width 27" (68.6 cm) Max. from the left or Recommended Cabinet right Cutout Location from Floor i3 i/4" (33.7 cm) Junction (68.6 cm) Cutout Location Width...
- Page 6 Installation Instructions IAICutout for 27" (68.6 Built-In cm)Single Ovens only Under Counter For JKS10, JKP30, JKP70, PK916, ZEK938 models only. Gas or electric cooktops may be installed over this oven. See cooktop installation instructions for cutout size, See label on top of oven for approved cooktop models.
- Page 7 Cabinetry Cutout for 27" (68.6 c_)Single or Double uilt-ln Ovens only-Over arming Drawer For JKSI0, JKP30, JKP35, JKP55, JKP70, JKP75, PK916, PK956, ZEK938, ZEK958 models only. Double 27" (68.6 cm) Single 27" (68.6 cm) Oven Over Oven Over a Warming Drawer a Warming Drawer Anti-Tip Block...
- Page 8 Cabinetry Cutoutfor 27"(68.6 _)Single Ovensonly- Belowan Advantiumor ;rowaveOven or Betweenan Advantiumor crowave Ovenand a rmingDrawer For JKSI0, JKP30, JKP70, PK916, ZEK938 models only. Single 27" (68.6 cm) Oven Single 27" (68.6 cm) Oven Below an Advantium or Between an Advantium or Microwave Oven Microwave Oven and a Warming Drawer...
- Page 9 Installation Instructions Cutout for Built-In 30"(76.2 cm)Single Ovens only For JTP30, JTP70, PT916, PT920, ZET938 models only. Cutout 7 3/4" (19.7 cm) Cabinet Width 30" (76.2 cm) Width Max. Junction Box 28 1/2" (72.4 cm), Location Recommended Cutout Location 28 5/8" (72.7 cm). may be "====_: Max.
- Page 10 Installation Instructions IAICutout f or30' 6.2 Built-In Ovens only cm)Double For JTP35, JTP55, JTP75, PT956, PT960, ZET958 models only. Cutout 7 3/4" 30" (76.2 cm) Cabinet Width Width (19.7 cm Junction Box ) Location 28 1/2" (72.4 cm) Recommended (junction box Min, --)- Cutout Location...
- Page 11 Installation instructions Built-inOvens Cutout for 30"( 6.2 c m) only nder Counter For JTP30, JTP70, PT916, PT920, ZET938 models only. Gas or electric cooktops may be installed over this oven. See cooktop installation instructions for cutout size. See label on 240V / 208V top of oven for approved cooktop models.
- Page 12 Cabinetry Cutout for Single or Double 30"(76.2cm) Built-In Ovens only- Over a Warming Drawer For JTP30, JTP35, JTP55, JTP70, JTP75, PT916, PT920, PT956, PT960, ZET938, ZET958 models only. Double 30" (76.2 cm) Single 30" (76.2 cm) Oven Over a Warming Oven Over a Warming Drawer Drawer...
- Page 13 Cabinetry [_ Cutoutfor 30"(76.2 c_)Single Ovens only - Below an Advantium or :rowave Oven or Between an Advantium or crowave Ovenand a rmingDrawer For JTP30, JTP70, PT916, PT920, ZET938 models only. Single 30" (76.2 cm) Oven Single 30" (76.2 cm) Oven Below an Advantium or Between an Advantium or Microwave Oven...
-
Page 14: Electrical Connections
Installation Instructions Electrical Connections Turn off the circuit breaker or remove ATTENTION INSTALLER fuses to the oven branch circuit. All electric wall ovens must be hard wired With the oven supported on a table or (direct wired) into an approved junction platform in front of the cabinet opening, box. - Page 15 Installation Instructions New Construction Three-Conductor Branch Four-Conductor Branch Circuit Connection Circuit Connection When connecting to a three-conductor branch circuit, if local codes permit: • When installing in new construction, a. Connect the bare oven ground conductor • When installing in a mobile home, or with the crimped neutral (white) lead to •...
- Page 16 Installation Instructions lcl Securing the Oven in the Opening Sliding the Oven Into the Drilling the Pilot Holes and Opening Mounting the Oven a. Loop (do not tie) a 36" (91 cm) string around the conduit before the oven is slid NOTE: Before drilling the pilot holes, into place.
- Page 17 Installation Instructions Installing the Metal Preparing for the Bottom Bottom Trim Trim Installation Place the bottom metal trim centered over a. With oven installed, take the bottom trim the pre-drilled mounting holes. Tape the and center it on the bottom front edge of edges of the trim down to maintain the the cabinet opening.
- Page 18 Installation Instructions ID-I R eplacing the Oven Door Open the oven door as far as it NOTE: The oven door is heavy. You will open. may need help lifting the door high enough to slide it into the hinge slots. Push the hinge locks up against the Do not lift the door by the handle.
-
Page 19: Pre-Test Checklist
Installation Instructions Pre-Test Checklist Check that the bottom trim is installed emove all protective film, if present, and any stickers. properly (see page 17). Check to be sure the mounting screws heck to be sure that all wiring is are installed and flush with the side trim secure and not pinched or in contact with moving parts. - Page 20 Notes...