Trim Meter; Trim Meter (Digital Type); Hour Meter (Digital Type) - Yamaha F50 Owner's Manual
Hide thumbs
Also See for F50:
- Owner's manual (116 pages) ,
- Rigging manual (497 pages) ,
- Maintenance manual (36 pages)
Table of Contents
Advertisement
Basic components
NOTE:
After the main switch is first turned on, all
segments of the display come on as a test.
After a few seconds, the gauge will change
to normal operation. Watch the gauge when
turning on the main switch to make sure all
segments come on.
NOTE:
The speedometer displays km/h, mph, or
knots, according to operator preference. Se-
lect the desired unit of measurement by set-
ting the selector switch on the back of the
gauge. See the illustration for settings.
1. Cap
2. Selector switch (for speed unit)
3. Selector switch (for fuel sensor)
EMU26610
Trim meter
This gauge shows the trim angle of your out-
board motor.
24
NOTE:
Memorize the trim angles that work best for
your boat under different conditions. Adjust
the trim angle to the desired setting with the
power trim and tilt switch.
EMU26620
Trim meter (digital type)
This meter shows the trim angle of your out-
board motor.
NOTE:
Memorize the trim angles that work best
G
for your boat under different conditions.
Adjust the trim angle to the desired using
the power trim and tilt switch.
If the trim angle of your motor exceeds the
G
trim operating range, the top segment on
the trim meter display will blink.
EMU26650
Hour meter (digital type)
This meter shows the number of hours the
ZMU04581
ZMU01740
- Quick Links:
- Changing Engine Oil
Hide quick links:
Advertisement
Table of Contents
