Table of Contents
Advertisement
12
STEP 1
STEP 2
STEP 3
203
Voice VLAN Constraints
The following constraints exist:
•
Only one Voice VLAN is supported.
•
A VLAN that is defined as a Voice VLAN cannot be removed
In addition the following constraints are applicable for Telephony OUI:
•
The Voice VLAN cannot be VLAN1 (the default VLAN).
•
The Voice VLAN cannot be Smartport enabled.
•
The Voice VLAN cannot support DVA (Dynamic VLAN assignment).
•
The Voice VLAN cannot be the Guest VLAN if the voice VLAN mode is OUI.
If the voice VLAN mode is Auto, then the Voice VLAN can be the Guest
VLAN.
•
The Voice VLAN QoS decision has priority over any other QoS decision,
except for the Policy/ACL QoS decision.
•
A new VLAN ID can be configured for the Voice VLAN only if the current
Voice VLAN does not have candidate ports.
•
The interface VLAN of a candidate port must be in General or Trunk mode.
•
The Voice VLAN QoS is applied to candidate ports that have joined the
Voice VLAN, and to static ports.
•
The voice flow is accepted if the MAC address can be learned by the
Forwarding Database (FDB). (If there is no free space in FDB, no action
occurs).
Voice VLAN Workflows
The device default configuration on Auto Voice VLAN, Auto Smartports, CDP, and
LLDP cover most common voice deployment scenarios. This section describes
how to deploy voice VLAN when the default configuration does not apply.
Workflow1: To configure Auto Voice VLAN:
Open the VLAN Management > Voice VLAN > Properties page.
Select the Voice VLAN ID. It cannot be set to VLAN ID 1 (this step is not required for
dynamic Voice VLAN).
Set Dynamic Voice VLAN to Enable Auto Voice VLAN.
Cisco Small Business 300 Series Managed Switch Administration Guide
VLAN Management
Voice VLAN
Advertisement
Table of Contents
