Table of Contents
Advertisement
Setup Advanced Settings - VPN Termination - Status Page
The following illustration is an example of a blank Setup Advanced Settings - VPN
Termination - Status page. No VPN tunnels are configured.
Setup Advanced Settings - VPN Termination - Status Page Description
This section describes the section headings and field descriptions of the Setup
Advanced Settings - VPN Termination - Status page. This page allows you to create,
configure, and control IPsec VPN tunnels.
Note: You can set up and mange up to 50 different VPN tunnels.
Field Name
IPsec Endpoint
Name
Status
Control
Configure
Add New Tunnel
Event Log
4024320 Rev A
Description
Enables/disables the IPsec endpoint mode
Displays the user-defined tunnel name entered from the VPN Setup
page
Displays the current connection state (Connected/NOT Connected)
Displays one of the following three keys based on the current tunnel
enable and connection state:
Enable
Connect
Endpoint disabled
Displays Edit or Delete keys used for settings management
Allows you to create a new tunnel configuration. When you click Add
New Tunnel, the VPN Setup page opens
Allows you to access the Event Log page. The Event Log page shows a
history of VPN connections and activity in chronological order and also
displays the IP address of both endpoints on the tunnel (local and
remote)
Note: On the Event Log page, pressing the Refresh key updates the
Event Log table to show any changes since the page was loaded.
Pressing the Clear key clears the log table of its current contents and
only the most recent data appears
How Do I Configure My DOCSIS Residential Gateway?
57
Hide quick links:
Advertisement
Table of Contents
