Oven Racks - GE PT7050SFSS Owner's Manual
Direct air convection built-in electric 30" single/double wall oven
Hide thumbs
Also See for PT7050SFSS:
- Installation instructions manual (17 pages) ,
- Dimensions and installation information (3 pages)
Table of Contents
Advertisement
Oven Racks
The racks that were provided with your oven (dark
enameled racks, not shiny) may remain in the oven
during the self-cleaning cycle without being damaged.
To manually clean racks, use warm, soapy water. Make
sure not to wash the rack slides on an extension rack.
If racks become more difficult to remove from the oven,
put some vegetable oil on a soft cloth or paper towel
and rub onto the oven rack supports. Do not wipe the
oil on an extension rack slide.
Periodically, after several self-clean cycles, the
extension rack slides may need to be lubricated using
the graphite lubricant shipped with your wall oven. To
order additional graphite lubricant read the Assistance
and Accessories sections at the beginning of this
manual.
1. Remove extension rack from the oven. See the
Extension Oven Racks section.
2. Fully extend the rack on a table or countertop.
Newspaper may be placed underneath the rack for
easy clean up.
3. If there is debris in the slide tracks, wipe it away
using a paper towel. NOTE: Any graphite lubricant
wiped away must be replaced.
4. Shake the graphite lubricant before opening it.
Starting with left slide mechanism of the rack,
place four (4) small drops of lubricant on the two
(2) bottom tracks of the slide close to the bearing
carriers.
5. Repeat for the right slide mechanism of the rack.
6. Open and close the rack several times to distribute
the lubricant.
7. Replace the cap on the lubricant and shake it again.
Turn the rack over and repeat steps 3, 4, 5 and 6.
8. Close the rack, turn rack right-side-up and place in
the oven. See the Extension Oven Racks section.
9. Repeat above steps for each rack.
NOTE: Do not spray with cooking spray or other
lubricant sprays.
Probe
The temperature probe may be cleaned with soap and
water or a soap-filled scouring pad. Cool the temperature
probe before cleaning. Scour stubborn spots with a soap-
filled scouring pad, rinse and dry.
To order additional temperature probes read the
Assistance and Accessories sections at the beginning of
this manual.
Do not immerse the temperature probe in water.
Do not store the temperature probe in the oven.
Do not leave the temperature probe inside the oven
during a self or steam clean cycle.
18
49-80668-2
Hide quick links:
Advertisement
Table of Contents
