Advertisement
: Before attempting to remedy one of the
following causes, switch the dryer off and switch on again
to start the programme again.
Ventilation to and from the
dryer may be insufficient
(e.g because it is installed in
a small room). This has
caused the temperature in
the room to rise sharply.
The fluff filters are clogged
up with fluff or were still wet
when they were replaced.
The laundry has not been
spun sufficiently.
The tumble dryer has been
overloaded.
Metallic components, e.g.
zips have prevented the
dryer from registering the
correct moisture level in the
laundry.
Detergent residues, hair and
fine fibres can block up the
condenser unit.
The vents below the door
are blocked.
Open a door or window
while the machine is in
operation for increased air
flow.
– Remove any fluff.
– The fluff filters must be
completely dry.
Make sure that your laundry
is thoroughly spun at
highest spin speed for the
type of fabric.
Do not exceed the maximum
load for the programme
selected.
– Close zips and fasten any
hooks next time.
If the problem occurs again,
dry garments with long zips
using "Timed drying - Warm
air".
Check the condenser unit
from time to time and clean
it if necessary (see
"Cleaning and Care").
Remove any objects that are
blocking the vents.
31
Advertisement
