hit counter script
Miele T 240 Operating Instructions Manual
  1. Manuals
  2. Brands
  3. Miele Manuals
  4. Dryer
  5. T 240
  6. Operating instructions manual
Miele T 240 Operating Instructions Manual

Miele T 240 Operating Instructions Manual

Vented tumble dryer
Hide thumbs

Advertisement

Table of Contents

Operating instructions

for vented tumble dryer
T 240
G
To avoid the risk of accidents
or damage to the machine
it is
to read these
Operating instructions before
it is installed or used for the first time.
M.-Nr. 05 538 690

Advertisement

Table of Contents
loading

Related Manuals for Miele T 240

Summary of Contents for Miele T 240

  • Page 1: Operating Instructions

    Operating instructions for vented tumble dryer T 240 To avoid the risk of accidents or damage to the machine it is to read these Operating instructions before it is installed or used for the first time. M.-Nr. 05 538 690...

  • Page 2: Table Of Contents

    ........4 ......... . 7 Disposal of the packing material .
  • Page 3 ..........22 General problems .
  • Page 4 Repairs should only be un- operation. dertaken by a Miele approved techni- Do not let small children play with the cian. machine or its controls. Supervise its Ensure current is not supplied to the use by the elderly or infirm.
  • Page 5 Adequate ventilation is essential, aged it must be replaced with an especially where another appli- Miele original cable. ance which also uses the room air (e.g. gas, oil or coal fired heater, continuous In the event of a fault or for clean-...
  • Page 6 Always close the door after use. This way you will avoid the danger Accessory parts may only be fitted when expressly approved by Miele. – children climbing onto or into the If other parts are used, guarantee, per- dryer or hiding things in it.
  • Page 7 ^ Make sure that your laundry is thor- oughly spun before drying. The transport and protective packing has been selected from materials which The higher the spin, the greater the are environmentally friendly for disposal savings that can be made in energy and can normally be recycled.
  • Page 8 Press the START button to start a show the drying stage reached; programme. The Start indicator lamp will flash as soon as a programme can be See "Problem solving guide" for infor- started. It lights up constantly once mation on the check lamps. the programme has started.
  • Page 9 The indicator lamp marked PC on the fascia panel is the interface used by the Miele service technicians for updat- ing the machine’s programme data. The following can be programmed into your machine using the programme se- lector in combination with the buttons.
  • Page 10 Pure linen should only be machine dried if specified as suitable by the Before drying check the drying sym- manufacturer on the wash care label, bol on the wash care label. as the surface of the fabric may other- wise "roughen". These items can be Significance of symbols: partially dried using the Smoothing programme.
  • Page 11 Drying levels maximum load: 5 kg Multi-layered fabrics, which Do not dry jersey wear in the would not be thoroughly Extra dry programme - ten- dried using the "Normal +" dency to shrink. programme. Single and multi-layered fab- rics, e.g. mixed load of cot- ton fabrics (e.g.
  • Page 12 Drying levels maximum load: 2.5 kg Minimum iron items which are Spin minimum iron fabrics for made of synthetic or blended at least 30 seconds in the fabrics (e.g. pullovers, washing machine before dry- dresses, trousers) which are ing. not dried adequately in the "Normal"...
  • Page 13 maximum load: 2 kg Woollen fabrics To refresh and fluff up woollen gar- ments quickly. Remove garments im- mediately at the end of the programme. Do not repeat. Woollen fabrics are not dried com- pletely by this programme. maximum load: 2.5 kg Cottons and linen fabrics.
  • Page 14 Do not overload the drum. Over- ^ As far as possible, sort laundry for: loading can cause unnecessary - the type of fibre or weave, wear and tear to the laundry and - the degree of dryness required, give a disappointing drying result. - similar size of items, - the moisture content after See the "Programme chart"...

  • Page 15: Control Panel

    ^ Turn the programme selector to the ^ Press the relevant button for the addi- required programme. tional option(s) required. COTTONS and It is not possible to activate additional MINIMUM IRON options which are incompatible with the The electronic unit uses the residual drying programme selected.

  • Page 16: Buzzer

    The drying stage reached is shown by the sequence indicator lamps on the For drying fabrics which can with- right hand side of the control panel. stand high temperatures, e.g. pure At the end of the drying phase, a cool- linens and cottons.
  • Page 17 Additional option(s) can be selected (point D) if required. Clean out airways This indicator lamp comes on to warn ^ Press the relevant button for the addi- you that the dryer is not working effi- tional option(s) required. ciently. This may be because: ^ Press the START button.

  • Page 18: Adding Or Removing Items

    ^ Press the Door button and open the If the programme selector is turned to a different programme after a programme door. has begun, this will not affect the Do not touch the back of the programme. The Anti-crease / Finish in- drum when adding or removing dicator lamp will flash.
  • Page 19 The system lock prevents anyone from interfering with the dryer. If the system lock has been activated it is not possible to start a programme. The following (A,B,C...) must be carried out A Ensure that the door is closed and that the programme selector is turned to Finish .
  • Page 20 A cleaning brush is available as an optional extra from your Miele dealer The fluff which is created by the dry- or the Miele Spare Parts Department. ing process is collected in the fluff fil- You can also use a vacuum cleaner.
  • Page 21 ^ Dry all parts with a soft cloth. A microfibre "E-Cloth" is available from the Miele UK Spare Parts Department, Part number 98013530, which is suit- able for cleaning surfaces such as stainless steel, glass, plastic and...
  • Page 22 With the help of the following notes minor faults in the performance of the appli- ance, some of which may result from incorrect operation, can be put right without contacting the Service Department. Repair work to electrical appliances should only be carried out by a suit- ably qualified person in accordance with local and national safety regulations.
  • Page 23 Fluff is principally the result Fluff is collected on the fluff of friction when garments filters and can be easily re- are being worn and moved (see "Cleaning and washed. Machine drying care"). hardly causes any fluff to form and, as has been es- tablished by research insti- tutes, has no effect on the lifetime of fabric.
  • Page 24 Before attempting to remedy one of the fol- lowing causes, switch the dryer off and switch on again to start the programme again. Ventilation to the dryer is in- Open a door or window sufficient (e.g because it is while the machine is in op- installed in a room which is eration for increased air too small).
  • Page 25 The system lock is acti- If you wish to use the dryer, vated. the system lock must be de- activated (see "Electronic sys- tem lock"). The fluff filter in the door is Clean the fluff filter (see blocked. "Cleaning and care"). The vent ducting or the Check all parts of the extrac- ventilation outlet (e.g.
  • Page 26 If the programme stops again and the "Clean out airways" indicator lamp flashes, there is a fault. Contact the Miele Service Department. The programme selector Turn the selector back to was moved after the be- the original position and ginning of a programme.
  • Page 27 This is not a fault. The electronics register whether Anti-crease/ there is laundry in the drum after the start of a Finish COTTONS or MINIMUM IRON programme. If the drum is empty the programme is stopped. The programme will also be stopped if the laundry is dry when the programme is started or if you are trying to dry an individual item.
  • Page 28 ^ Turn your wrist to make the cover open downwards. The temperature resistant lamp should only be ordered from your Miele dealer or the Miele Spare Parts Department. The lamp must not exceed the maxi- mum wattage quoted on the data plate and on the lamp cover.
  • Page 29 When contacting the Service Depart- Optional accessories for these dryers ment, please quote the model and se- are available from your Miele Dealer or rial number of your appliance, both of from the Miele Spare Parts Department. which are shown on the data plate situ- ated on the right hand side below the drum aperture.
  • Page 30 a Venting connection: rear, right or left (supplied with the rear socket open) b Supply cable for electrical connec- tion c Control panel d Door e Four height-adjustable screw feet...
  • Page 31 * Available as an optional accessory from your Miele dealer or the Miele Spare Parts Department. The building under kit is supplied with its own installation instructions. When moving the machine you can hold it by the lid where it protrudes to When built under running times may be the rear of the dryer.

  • Page 32: Tumble Dryer

    The tumble dryer can also be com- bined with a Miele washing machine in a washer-dryer stack. To do this the appropriate stacking kit* (WTV) to match your washing machine is re- quired.
  • Page 33 All electrical work should be carried out only by a suitably qualified and compe- If this machine is fitted with a tent person, in strict accordance with non-rewireable plug and the socket out- national and local safety regulations. lets are not suitable for the plug sup- plied or if the existing plug needs to be Ensure power is not supplied to the ap- replaced by a new one, the old plug will...
  • Page 34 If the colours of the wires in the mains lead of this appliance do not corre- spond with the coloured markings iden- tifying the terminals of your plug, pro- ceed as follows: ^ The wire which is coloured green and yellow must be connected to the ter- minal in the plug which is marked with the letter E or by the earth sym-...
  • Page 35 . . . cannot cause a nuisance or any *These can be obtained from the Miele damage to the building. Spare Parts department or from build- –...
  • Page 36 ^ Refer to for the appropriate duct diameter for the effective duct Friction against the inner walls of the length. vent duct will slow down the expelled air as it passes through the duct. An el- bow, bend, non-return flap or wall vent creates more friction than a straight duct.
  • Page 37 The connection is opened at the fac- tory. ^ Fit one of the venting systems de- scribed on the following pages. = 1 x 3.8 m Additional duct = 3.8 m length = 2 x 0.8 m Additional duct = 1.6 m length = 0.5 x 1 m Additional duct = 0.5 m...
  • Page 38 . . . flexible ducting hose . . . a wall vent kit* or window vent kit*. * (Miele optional accessory). A Insert the Miele adapter (1) into the vent opening of the dryer. B Attach the hose (2). ^ Installation examples are shown on...
  • Page 39 Connection to an exhaust flue Window vent 1. Pipe with connection piece (= supplied with the Miele wall vent kit) 1. Window vent kit (fitted in a "plexi- glass" pane) 2. Adapter for flexible hose (separate fitting instructions are sup- 3.
  • Page 40 Where the pipe diameter (Separate fitting instructions are is more than 100 mm, an adapter is supplied with the Miele wall vent kit) necessary (e.g. 100 to 125 mm C) to 2. Adapter connect the pipe to the dryer.

  • Page 41: Optional Accessories

    ^ A wall pipe* and a flexible foam gas- ket* must be used * (both Miele optional accessories). A Before drilling into the wall, . . . please read the installation in- structions supplied with the Miele 1.
  • Page 42 Miele washing machine with Comfort line angled fascia Miele washing machine with straight or sloping fascia Spacer kit* without worktop: C = 94.2 cm D = 170.0 cm Spacer kit* without worktop: Spacer kit* with worktop: A = 94.2 cm C = 96.0 cm...
  • Page 43 Minutes 1200 3.15 1400 3.00 1600 2.75 1200 2.70 1400 2.60 1600 2.30 800 (70 % residual moisture) 3.30 1200 2.60 1400 2.45 1600 2.20 800 (70 % residual moisture) 2.60 1200 1.90 1400 1.80 1600 1.50 1200 1.50 1400 1.40 1600 1.15...
  • Page 44 Height 85 cm (adjustable +0.7/-0.7 cm) Height without lid 82 cm Width 59.5 cm Depth 58 cm Weight 48 kg Drum volume 100 litres Maximum capacity 5 kg dry weight Length of connection cable 1.60 m Voltage see data plate Rated load see data plate Fuse rating...
  • Page 45 Programmable functions for changing standard settings...

  • Page 46: Increased Drying Level

    – If the Machine iron sequence indica- tor does not light up, the increased The machine is designed to dry us- drying level is ing as little energy as possible. How- – If the Machine iron indicator lamp ever, if you require the laundry to be lights up, the increased drying level drier, it is possible to reduce the final moisture level in the COTTONS and...

  • Page 47: Memory Function

    D Turn the programme selector to COT- TONS Normal . The additional options selected previ- – If the Machine iron sequence indica- ously for specific programmes are tor does not light up, the Memory stored in the machine’s memory. function is The machine is supplied ex-works with –...

  • Page 48: Anti-Crease

    D Turn the programme selector to COTTONS Hand iron r. Once a programme has ended, the – If the Machine iron indicator lamp drum will turn at regular intervals for lights up, the anti-crease function approx. 60 minutes to prevent the laundry from settling into creases or folds.
  • Page 52 Alteration rights reserved/4302 M.-Nr. 05 538 690 / V02 This paper consists of cellulose which has been bleached without the use of chlorine.

Table of Contents