Page 2
IMPORTANT This product complies with the Low Voltage Directive (73/ 23/EEC), EMC Directives (89/336/EEC, 92/31/EEC) and CE The accessory power cord can only be used on the continent Marking Directive (93/68/EEC). of North America. In Europe, do not use the accessory power cord.
7 CONTENTS Thank you for buying this PIONEER product. Please read through these operating instructions so you will INSTALLATION-RELATED PRECAUTIONS ..5 know how to operate your model properly. After you have finished reading the instructions, put them away in a safe PRIOR TO USING THIS PRODUCT ....
Page 4
IMPORTANT! SAFETY INSTRUCTIONS 1. READ INSTRUCTIONS – All the safety and operating 10. PLUG – This product is equipped with a wired grounding 15. SERVICING – Do not attempt to service this product instructions should be read before the appliance is type plug (a plug having a third (grounding) pin).
INSTALLATION-RELATED PRECAUTIONS 7 Operating Environment: 7 Operating Precautions: ÷ Operating Temperature Range: +5 °C to +30 °C ÷ Maintain a cleared area around the air intake vent to ÷ Operating Humidity Range: 10 % to 80 % prevent the internal temperature of the drive from (with no condensation) rising ÷...
÷ Remove dust or lint from the disc with a soft cloth by not in use wiping from the inside to the outside edge rather than in a circular motion 7 Disc-related: ÷ Discs appropriate for the DVR-S201 drive (show disc table) For writing For reading DVD-R (3.95 GB, 4.7 GB) DVD-ROM ÷...
PART NAMES AND FUNCTIONS Front Panel Rear Panel DVD-R DRIVE DVR-S201 SCSI TERMINATION SCSI DISC READ/WRITE 1 Disc tray 6 OPEN/CLOSE (0) button Place the disc on the tray with its label side facing up (Operate Opens and closes the disc tray...
CONNECTION 7 Setting the TERMINATION Switch The power cord and SCSI cable (sold on the market) must be connected for operation of this drive. SCSI cable After connecting the cord and cable, set the TERMINATION switch and the SCSI ID. Computer When connecting the cord and cable or changing connections and settings, turn OFF the POWER switch then unplug the...
Check the power cord once in a while. When you find it damaged, ask your nearest PIONEER authorized service center or your dealer for a replacement. <DRC1101>...
OPERATION 7 Starting Up the DVD-R System The DVD-R writing system consists of a personal computer (PC) and the DVD-R Drive. 1. Turn ON the power to the DVD-R Drive. In order to operate the DVD-R Drive, the accompanying 2. Turn ON the power to the PC. application software and disc driver must be installed on the 3.
Page 11
OPEN/CLOSE button or a software command. ÷ A disc that you need to eject remains inside the device but DVD-R DRIVE the power is off. DVR-S201 1. Confirm that the power for the device is OFF and that the DISC READ/WRITE disc has stopped spinning.
OTHER USEFUL INFORMATION Troubleshooting DVD-R Discs 7 When data cannot be recorded or errors If you suspect trouble, check the status of operations for the following situations: occur during recording: ÷ Is the disc one that may be used with this device? 7 The power indicator does not light.
Page 14
PIONEER NEW MEDIA TECHNOLOGIES, INC. Multimedia and Mass Storage Division: 2265 East 220th Street, Long Beach, CA 90810, U.S.A. TEL:800-444-OPTI (6784) PIONEER ELECTRONICS SERVICE, INC. 1925 East Dominguez St. Long Beach, CA 90810, U.S.A. TEL: 310-952-2820 PIONEER ELECTRONIC [EUROPE] N.V.