Replacing The Fuel Filter; Electrical System Maintenance; Charging The Battery - Toro TimeCutter Z380 Operator's Manual
Hide thumbs
Also See for TimeCutter Z380:
- User manual (188 pages) ,
- Service manual (72 pages) ,
- Operator's manual (44 pages)
Table of Contents
Advertisement
G000534
1.
Hose clamp
2.
Fuel line
Figure 30
3.
Filter
3
5.
Pull the fuel line off of the fuel filter (Figure
30).
6.
Open
the fuel shut-off
valve. Allow
gasoline
to
drain into a gas can or drain pan.
Note:
Now
is the best time to install a new
fuel filter because
the fuel tank is empt>
7.
Install
the fuel line onto
the fuel filter. Slide
the hose clamp close to the fuel filter to secure
the fuel line (Figure
30).
Replacing
the Fuel Filter
Replace
the fuel filter after every 100 operating
hours
or yearly whichever
occurs
first.
Never install a dirty filter if it is removed from the
fuel line.
1. Park the machine on a level surface and
disengage the blade control switch.
2. Move the motion control levers to the brake
position, stop the engine, remove the ke5 and
wait for all moving parts to stop before leaving
the operating position.
3. Close the fuel shut-off valve located under the
front of the fuel tank.
,
Squeeze the ends of the hose clamps together
and slide them away from the filter (Figure 30).
5. Remove the filter from the fuel lines.
,
Install a new filter and move the hose clamps
close to the filter (Figure 30).
7. Open the fuel shut-off valve.
Electrical System
Maintenance
CALIFORNIA
Proposition
65 Warning
Battery
posts,
terminals,
and
related
accessories
contain
lead
and
lead
compounds,
chemicals
known
to the State
of
California
to cause
cancer
and reproductive
harm.
Wash
hands
after handling.
Charging
the Battery
Removing
the Battery
Battery
terminals
or metal tools could short
against
metal machine
components
causing
sparks.
Sparks can cause the battery
gasses
to explode,
resulting
in personal
injury.
•
When
removing
or installing
the battery,
do not allow
the battery
terminals
to
touch
any metal
parts
of the machine.
•
Do not allow metal
tools
to short
between
the battery
terminals
and metal
parts
of
the machine.
1. Park the machine on a level surface and
disengage the blade control switch.
2. Move the motion control levers to the brake
position, stop the engine, remove the keB and
wait for all moving parts to stop before leaving
the operating position.
3. Tip the seat forward to see the batter>
4. Disconnect
the negative (black) ground cable
from the battery post (Figure 31).
27
Hide quick links:
Advertisement
Table of Contents
