Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Zanussi ZWG1100 P
Summary of Contents for Zanussi ZWG1100 P
- Page 1 User manual Washing Machine ZWG1100 P ZWG1121 P 147214441...
-
Page 2: Table Of Contents
Contents Safety information ........Control panel..........Environment concerns....... Set your washing program......Product description........International wash code symbols....Technical data........... Programs informations....... Installation..........Washing programs........First use............ Care and cleaning........Daily use........... Something not working......Safety information Important! Only use the advised quantities of fabric softener and detergent. -
Page 3: Child Safety
Installation Garments which have been in contact with volatile petroleum products should not be This appliance is heavy. Care should be machine washed. If volatile cleaning fluids taken when moving it. are used, care should be taken to ensure When unpacking the appliance, check that that the fluid is removed from the garment it is not damaged. -
Page 4: Environment Concerns
Environment concerns Packaging materials With adequate pre-treatment, stains and limited soiling can be removed; the laundry The materials marked with the symbol can then be washed at a lower temperature. recyclable. Measure out detergent according to the >PE<=polyethylene water hardness, the degree of soiling and the >PS<=polystyrene quantity of laundry being washed. -
Page 5: Product Description
Product description Front View Back View Detergent Dispenser Drawer Front Feet Water Drain Hose Hose Holders Worktop Water Inlet Hose Drain Hose Support Back Feet Control Panel Mains Cable Door Opening Handle Technical data Dimensions 60 cm Width Height 85 cm Depth 54 cm Power supply voltage/frequency... -
Page 6: Installation
Installation Unpacking Remove the polystyrene base, set the machine upright and unscrew the remaining Important! rear screw. Slide out the relevant All transit bolts and packing must be pin. removed before using the appliance. You are advised to keep all transit devices so that they can be refitted if the machine ever has to be transported again. -
Page 7: Water Drainage
Positioning Water drainage The end of the drain hose can be positioned in Install the machine on a flat hard floor. three ways: Make sure that air circulation around the Hooked over the edge of a sink using the machine is not impeded by carpets, rugs etc. plastic hose guide supplied with the Check that the machine does not touch the machine. -
Page 8: First Use
Electrical Connection Important! This machine is designed to operate on a Connect the machine to an earthed socket. 220-240 V, single-phase, 50 Hz supply. The manufacturer declines any responsibility “An incorrect power supply may void your for damage or injury through failure to comply warranty.”... - Page 9 Rust: oxalic acid dissolved in hot water or a Cotton, linen: drum full but not too tightly rust removing product used cold. Be careful packed; with rust stains which are not recent since the Synthetics: drum no more than half full; cellulose structure will already have been Delicate fabrics and woollens: drum no damaged and the fabric tends to hole.
- Page 10 Do not spray stain pre-treatment products Compartment : this compartment is (e.g. Vanish) on or near the machine, as it used for washing powder or liquid. can attack plastic materials reducing its life. Compartment : this compartment is used for fabric conditioner and starching agent. Quantity of detergent to be used Aways add laundry detergents before switching The type and quantity of detergent will depend...
-
Page 11: Control Panel
Clip the flap down if you are going to use If you wish to carry out the “prewash” phase, liquid detergent. pour it into the compartment marked “ ”. Refit the dispenser back into its runners. If required, pour fabric softener into the compartment marked (the amount used Remember:... -
Page 12: Set Your Washing Program
Set your washing program Program selector dial Turn the program selector dial to the required program. The green Start/Pause light starts to flash. The selector dial is divided into following sections: (Cancelling/Off) Rinse Drain Cottons Spin Prewash Economy Easy Iron 5 Shirts Synthetics Mixed Fabric... -
Page 13: Spin Buttons
Spin Buttons Auto Spin Reduction ( ): by selecting a programme, the appliance proposes automatically the maximum spin speed provided for that programme. By selecting Automatic Spin reduction the spin speed is reduced to a half, but not less than 400 rpm. The relevant light illuminates. Rinse Hold ( ): by selecting this option the water of the last rinse is not emptied out to prevent the fabrics from... - Page 14 Important! The selected delay can be changed only after selecting the washing program again. The door will be locked throughout the delay time. If you need to open the door, you must first set the washing machine to PAUSE by pressing the Start/Pause button and then wait about 3 minutes.
-
Page 15: International Wash Code Symbols
Altering an option or a running program Opening the door after the program has started It is possible to change any option before the program carries it out. The option “Super Quick” If you need to open the door, you must first cannot be modified after the Start/Pause has set the washing machine to PAUSE by been pressed. -
Page 16: Programs Informations
Programs informations To reset a programme and to switch off the machine turn the selector dial to “O”. Now, a new programme can be selected. (Cancelling/Off) Washing programme for white and coloured cottons fabrics. Cottons Cottons select this program if you wish your laundry to be prewashed at 30° C Prewash before the main wash. -
Page 17: Washing Programs
Washing programs Type of laundry Max. Program/ Description Options Load Temperature of program (1200 rpm for ZWG 1121P, Main wash at White, coloured cotton 1000 rpm for ZWG 1100P) Cold - 90° C Cottons - Rinse Hold ( and linen (Normally Rinses - Super Quick - 90°... -
Page 18: Care And Cleaning
Type of laundry Max. Program/ Description Options Load Temperature of program For emptying out the Drain of Not available Drain water left in the drum. water (1200 rpm for ZWG 1121P, Separate spin program Drain 1000 rpm for ZWG 1100P) for spin out the water Spin Long spin... -
Page 19: External Cleaning
use a small brush To run a maintenance wash: to clean the recess. The drum should be empty of laundry. Select the hottest cotton wash program. Use a normal measure of detergent, must be a powder with biological properties. External cleaning Replace the drawer and run the rinse programme without any clothes in the drum. -
Page 20: Something Not Working
Something not working Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer. Before contacting your local Service Centre, please carry out the checks listed below. During machine operation it is possible that the red Start/Pause pilot light flashes to indicate that the machine is not working. - Page 21 Malfunction Possible cause Solution Too much detergent or unsuitable Reduce the detergent quantity or detergent (creates too much foam) use another one. has been used. Check whether there are any leaks Check the water inlet hose from one of the inlet hose fittings. It is connection.
- Page 22 Malfunction Possible cause Solution The electronic unbalance detection Redistribute the laundry. device has cut in because the laundry is not evenly distributed in the drum. The laundry is redistributed by reverse rotation of the drum. This Spinning starts may happen several times before the late or the unbalance disappears and normal machine does not...
- Page 24 www.zanussi.com/shop...