Sip And Spa Product Overview; Introduction To Sips And Spas; Spa Interface Processors - Cisco CRS-1 - Carrier Routing System Router Hardware Installation Manual
Carrier routing system sip and spa
Hide thumbs
Also See for CRS-1 - Carrier Routing System Router:
- Administration manual (436 pages) ,
- Getting started manual (289 pages) ,
- Troubleshooting manual (264 pages)
Table of Contents
Advertisement
SIP and SPA Product Overview
This chapter provides an introduction to SPA interface processors (SIPs) and shared port adapters
(SPAs). It includes the following sections:
•
•
•
For software configuration information for the various SIPs and SPAs that are supported on the
Cisco CRS-1 router, refer to Cisco IOS XR Interface and Hardware Component Configuration Guide at
the following URL:
http://www.cisco.com/en/US/partner/products/ps5845/products_installation_and_configuration_guides
_list.html
For information on specific Cisco IOS XR software commands, refer to Cisco IOS XR Interface and
Hardware Component Command Reference at the following URL:
http://www.cisco.com/en/US/partner/products/ps5845/prod_command_reference_list.html
Introduction to SIPs and SPAs
SIPs and SPAs comprise a carrier card and port adapter architecture that increases modularity, flexibility,
and density across Cisco Systems routers for network connectivity. This section describes the SIPs and
SPAs and provides some guidelines for their use.
SPA Interface Processors
The following list describes some of the general characteristics of a SIP:
•
•
•
•
OL-17439-01
Introduction to SIPs and SPAs, page 1-1
SIP and SPA Compatibility, page 1-3
Modular Optics Compatibility, page 1-3
A SIP is a carrier card that is similar to a physical layer interface module (PLIM)s and inserts into
a line card chassis slot like any other PLIM. Unlike PLIMs, SIPs provide no network connectivity
on their own.
A SIP contains one or more subslots, which are used to house one or more SPAs. The SPA provides
interface ports for network connectivity.
During normal operation, the SIP should reside in the router fully populated, either with functional
SPAs in all subslots or with a blank filler plate (SPA-BLANK=) inserted in all empty subslots.
SIPs support online insertion and removal (OIR).
Cisco CRS-1 Carrier Routing System SIP and SPA Hardware Installation Guide
1
C H A P T E R
1-1
Advertisement
Table of Contents
Troubleshooting
