Using The Default Setting Mode - Epson PRO Reference Manual

Epson stylus pro and pro xl color ink jet printer reference guide

Hide thumbs Also See for PRO:

Table of Contents

Alt/Cleaning Used in combination with other buttons to reset the

Using special button combinations

The functions listed below are available when you hold down a

combination of buttons when turning on the printer.

Self test (Operate + Load/Eject)

Checks the paper length and performs a self test by printing

fonts and colors. Hold down the Load/Eject button and then

press the Operate button for several seconds until the printer

advances a sheet of paper. See "Testing the Printer" in

Chapter 1 of the Setup and Software Guide. To stop the self test,

press Pause and then turn off the printer.

Hex dump (Operate + Font + Load/Eject)

On a PC, prints data in hexadecimal code for troubleshooting

analysis. See the Troubleshooting section in Chapter 3.

Default setting mode (Operate + Economy/Condensed)

Enters the Default setting mode. See "Using the Default Setting

Mode" on page 2-6 for more information.

Note:

To exit the hex dump or Default setting mode, press the Pause

button and then the Operate button to turn off the printer.

Reset printer (Alt + Pause)

Clears the printer's buffer and resets the printer settings to

their factory defaults. Hold down both buttons for about 5

seconds.

printer, clean the print heads, or adjust the paper

thickness lever. See "Cleaning the Print Heads" in

Chapter 3 and "Loading Envelopes and Heavy

Paper" in Chapter 1 for more information.

Controlling the Printer

2-5

Table of Contents

Troubleshooting