hit counter script
Download
Share
Print this page
Epson TC-1428 User Manual
  1. Manuals
  2. Brands
  3. Epson Manuals
  4. Monitor
  5. TC-1428
  6. User manual
Epson TC-1428 User Manual

Epson TC-1428 User Manual

14" svga color monitor
Hide thumbs

Advertisement

Quick Links

Download this manual
14" SVGA Color Monitor
TC-1428

Advertisement

loading

Related Manuals for Epson TC-1428

Summary of Contents for Epson TC-1428

  • Page 1 14" SVGA Color Monitor TC-1428...
  • Page 2 For 240V operation, use only with power cord plug having a tandem blade, grounding type plug, rated 250V 5A. VESA DPMS Compliance Product Information NOTE: The TC-1428 has been tested and found to comply with the requirement of VESA DPMS standard. The power management features are as follows: 1.
  • Page 3 2. The monitor will be automatically recovered to the on state by receiving normal sync. signals from PC. 3. The power management states are identified below: Power Mgmt. States Stand-By Power ON S u s p e n d O N Power OFF 1 Introduction..
  • Page 4 DO NOT REMOVE THE TILT/SWIVEL BASE! 2. The input power source: The TC-1428 is designed to be suitable for low input voltage (100- 125V) and high input voltage (200-240V) areas. 3. The monitor is equipped with a three-pronged grounding plug which will only fit a grounded power outlet.
  • Page 5 30 seconds before turning it on again. 1. The TC-1428 monitor automatically adapts to the vertical and horizontal frequencies of VGA, SVGA, 8514/A, VESA VGA, UVGA, and other compatible graphics adapters.

  • Page 6: Specifications

    Power Source: Power Consumption: Power Management: Picture Tube: Resolutions Horizontal: * Vertical: Input Signals * Video: * Separate Sync: Synchronization * Horizontal: * Vertical: Display Colors * ANALOG Input: Active Display Area * Horizontal: * Vertical: Dimension * (W)x(H)x(D): VESA DDC Standard: (Optional) Environmental Conditions * Operating Temperature:...
  • Page 7 Low Radiation: * X-ray radiation: < 100n Gylh * Magnetic field: Band I (5KHz-2KHz): < 250nT. Band II (2KHz-400KHz): < 25nT. Tilt and Swivel Operation: The swivel range is normally limited to a range of 45 degrees to the right or left of the front position (marked by a small molded pip on the top front bottom of the base).
  • Page 8 5. Control Locations and Adjustments Note: The numbers indicate the control item whose description is found on the following page. - 7 -...
  • Page 9 Adjustments 1. POWER Switch 2. BRIGHTNESS Control 3. CONTRAST Control 4. H. WIDTH Control 5. H. POSITION Control 6. V. HEIGHT Control 7. V. POSITION Control Push to turn the display on, and push again to turn off. The power indicator will light when the display is on.
  • Page 10 Your monitor has two connecting cables: a Power Supply Cord, which connects to a wall outlet, surge protector or other power source, and a Signal Cable, which connects to the graphics adapter of your computer. To insure safety and correct operation, always follow these four steps when connecting the monitor: 1.

  • Page 11: Pin Assignments

    The pin assignment of the video signal cable are shown below: 15-Pin Mini D-Sub Male Connector PIN NO. 7. Pin Assignments GREEN BLUE GROUND or OPEN FOR DDC GROUND R-GROUND G-GROUND B-GROUND NO CONNECTION GROUND or OPEN FOR DDC GROUND NO CONNECTION or DDC SDA H.

  • Page 12: Timing Charts

    SEPARATE SYNC. HORIZONTAL VERTICAL PRESET TIMING-VGA/SVGA Fh (KHz) A µs (Line time total) B µs (Synch. pulse) C µs (Back porch) D µs (Active) E µs (Front porch) Fv (Hz) P ms (Frame time total) Q ms (Synch. pulse) R ms (Back porch) S ms (Active) T ms (Front porch) H.
  • Page 13 PRESET TIMING-8514A/VESA VGA/UVGA Fh (KHz) A µs (Line time total) B µs (Synch. pluse) C µs (Back porch) D µs (Active) E µs (Front porch) Fv(Hz) P ms (Frame time total: Q ms (Synch. pulse) R ms (Back porch) S ms (Active) T ms (Front porch) Separate H.

  • Page 14: Troubleshooting

    Before you call an authorized service center, please check if the following items are properly connected or not. If a non-IBM personal computer or graphics adaptor is being used, make sure the pin assignments of signal input connector and the signal timing meet the specifications inducated above.
  • Page 15 Federal Communications Commission Requirements Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
  • Page 16 P/N:5035111312...

This manual is also suitable for:

Monitor-14" svga color monitor