Table of Contents
Advertisement
APPENDIX — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Symptom
The thread does
The needle was not raised.
not pass through
the eye of the
The needle is incorrectly installed.
needle.
The presser foot appropriate for the
type of stitch that you wish to sew is
not used.
The stitch is not
The thread tension is incorrectly set.
sewn correctly.
The thread is tangled, for example, in
the bobbin case.
The feed dogs are lowered.
The stitch is too short.
The fabric does
The combination of fabric, thread and
not feed.
needle is incorrect.
The thread is tangled, for example, in
the bobbin case.
The sewing lamp
does not come
The sewing lamp is damaged.
on.
86
Probable Cause
Remedy
Press
(needle position button)
once or twice to raise the needle.
Correctly install the needle.
Attach the presser foot that is
appropriate for the type of stitch that
you wish to sew.
Adjust the thread tension.
Remove the tangled thread. If the
thread is tangled in the bobbin case,
clean the race.
Slide the feed dog position switch to
.
Lengthen the stitch length.
Select a thread and needle that are
appropriate for the type of fabric
being sewn.
Remove the tangled thread. If the
thread is tangled in the bobbin case,
clean the race.
Contact your dealer or the nearest
authorized service center.
Reference
page 21
page 29
page 79
page 47
page 81
page 70
page 40
page 28
page 81
–
- Quick Links:
- Threading the Upper Thread
- Troubleshooting
Hide quick links:
Advertisement
Table of Contents
