Accelerated Aging To Retain Connectivity; Understanding Advanced Stp Features; Understanding Port Fast - Cisco WS-C3550-12G Software Configuration Manual
Multilayer switch
Hide thumbs
Also See for WS-C3550-12G:
- User manual (436 pages) ,
- Manual (278 pages) ,
- Datasheet (19 pages)
Table of Contents
Advertisement
Understanding Advanced STP Features
Accelerated Aging to Retain Connectivity
The default for aging dynamic addresses is 5 minutes, the default setting of the mac-address-table
aging-time global configuration command. However, an STP reconfiguration can cause many station
locations to change. Because these stations could be unreachable for 5 minutes or more during a
reconfiguration, the address-aging time is accelerated so that station addresses can be dropped from the
address table and then relearned. The accelerated aging is the same as the forward-delay parameter value
(spanning-tree vlan vlan-id forward-time seconds global configuration command) when STP
reconfigures.
Because each VLAN is a separate spanning-tree instance, the switch accelerates aging on a per-VLAN
basis. An STP reconfiguration on one VLAN can cause the dynamic addresses learned on that VLAN to
be subject to accelerated aging. Dynamic addresses on other VLANs can be unaffected and remain
subject to the aging interval entered for the switch.
Understanding Advanced STP Features
This section describes how advanced STP features work. It includes this information:
•
•
•
•
•
•
•
For configuration information, see the
Understanding Port Fast
Port Fast immediately brings an interface configured as a Layer 2 access port to the forwarding state
from a blocking state, bypassing the listening and learning states. You can use Port Fast on Layer 2
access ports connected to a single workstation or server, as shown in
to immediately connect to the network, rather than waiting for STP to converge.
If the interface receives a BPDU, which should not happen if the interface is connected to a single
workstation or server, STP puts the port in the blocking state. An interface with Port Fast enabled goes
through the normal cycle of STP status changes when the switch is restarted. For more information, see
the
Because the purpose of Port Fast is to minimize the time access ports must wait for STP to converge,
Note
it is effective only when used on access ports. If you enable Port Fast on a port connecting to another
switch, you risk creating a spanning-tree loop.
Catalyst 3550 Multilayer Switch Software Configuration Guide
10-10
Understanding Port Fast, page 10-10
Understanding BPDU Guard, page 10-11
Understanding UplinkFast, page 10-12
Understanding Cross-Stack UplinkFast, page 10-13
Understanding BackboneFast, page 10-18
Understanding Root Guard, page 10-20
Understanding EtherChannel Guard, page 10-20
"Configuring Port Fast" section on page
"Configuring Advanced STP Features" section on page
10-32.
Chapter 10
Configuring STP
Figure
10-4, to allow those devices
78-11194-03
10-32.
- Quick Links:
- Table of Contents
- Front Panel View
- Ip Addresses
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
