Step 9: How To Configure The Topology-Dependent Parameters - Cisco SFE2000P Installation And Configuration Manual
Configuration guide
Hide thumbs
Also See for SFE2000P:
- Datasheet (7 pages) ,
- Configuration manual (406 pages) ,
- Reference manual (286 pages)
Table of Contents
Advertisement
Chapter 5
Connecting the Management Interfaces and Performing Initial System Configuration
Enter SNMP trap manager community string:
Type the number of the trap manager SNMP version (1 or 2c) and press
Step 12
Enter
Step 13
Note that there is no default for this parameter.
Enter trap manager SNMP version:
The maximum number of trap managers is 20.
Step 14
•
•
•
•
•
Configure the Authentication Failure trap status.
Step 15
•
•
Enable the 'Authentication Failure' trap [no]:
Configure the SCE enterprise trap status.
Step 16
•
•
Enable the SCE enterprise traps []:
Type the name of the system administrator and press Enter.
Step 17
Note that there is no default for this parameter.
Enter system administrator contact name []:
EXAMPLE:
Following is a sample SNMP configuration, configuring one trap manager, one GET community, and
one SET community, and enabling the authentication failure trap, as well as all enterprise traps.
Would you like to enter the SNMP configuration menu? [no]: yEnable SNMP management? [no]:
yEnter SNMP GET community name[]: publicEnter Access list number allowing access with this
community string, use '0' to allow all: 0Would you like to add another SNMP GET community?
[no]:
Enter SNMP SET community name[]: privateEnter Access list number allowing access with this
community string, use '0' to allow all: 2Would you like to add another SNMP SET community?
[no]:
Would you like to configure SNMP trap managers? [no]: yEnter SNMP trap manager IP address:
10.1.1.253Enter SNMP trap manager community string: publicEnter trap manager SNMP version:
2cWould you like to add another SNMP trap manager? [no]:
Enable the 'Authentication Failure' trap [no]: yEnable SCE enterprise traps []: yEnter
system administrator contact name []: John Smith
Step 9: How to Configure the Topology-Dependent Parameters
The topology configuration menu is a series of guided questions relating to the deployment of the SCE
2000 in the network and its mode of operation. Values for the parameters are configured based on the
user answers.
OL-7824-06
To add more entries, type yand press
Enter
Would you like to add another SNMP trap manager? [no]:y
Enter up to 20 trap managers as described in through .
When all entries have been added, press
Enter
Would you like to add another SNMP trap manager? [no]:
To disable the Authentication Failure trap, press Enter.
To enable the Authentication Failure trap, type yand press Enter.
To disable the SCE enterprise traps, type npress Enter.
To enable the SCE enterprise traps, type yand press Enter.
Cisco SCE 2000 4xGBE Installation and Configuration Guide
Initial System Configuration
5-19
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
