• Do not remove items from the freezer compartment if your hands are damp/wet, as this could cause skin abrasions or frost/freezer burns. • Bottles and cans must not be placed in the freezer as they can burst when the contents freeze. • Manufacturers’ recommended storage times should be adhered to.
Contact your local Service Force Centre. Contents Instructions for the User Important Safety Instructions Operation Before use Freezer controls Starting your appliance Temperature control Warning light (red) Temperature acoustic alarm Freezing fresh food Frozen food storage Thawing...
To operate the freezer proceed as follows: Turn the thermostat control knob beyond the «0» position. When you first start the freezer, we suggest that you turn the thermostat control knob to a medium setting. For easier turning of this control, use a small coin.
After the time has elapsed place the food to be frozen in the two top compartments of the freezer as this is the coldest part; if freezing only a small amount of food, always use the top compartment.
• The best way to defrost food is to put it in the refrigerator to thaw slowly. • Ensure that food placed in the freezer is dated and labelled and used in date order to ensure that food is consumed at its best.
Important In the event of a power failure causing t h e temperature within your freezer to rise, do not re-freeze the food without checking its condition. The following guidelines should assist you: Ice-cream: once thawed should be discard- Fruits &...
Maintenance and Cleaning Warning Before any maintenance or cleaning work is carried out, DISCONNECT the appliance from the ELECTRICITY supply. Important This appliance contains hydrocarbons in its cooling unit maintenance and recharging must therefore only be carried out by authorised technicians. Internal cleaning Clean the inside and accessories with warm water and bicarbonate of soda (5ml to 0.5 litre of water).
Symptom No power to the appliance The temperature in the freezer is too high The freezer door will not open The compressor runs continuously Excessive frost and ice has built up.
“Something Not Working.” Customer Care Department For general enquiries concerning your Electrolux appliance or for further information on Electrolux products, please contact our Customer Care Department by letter or telephone at the address below or visit our website at www.electrolux.co.uk...
Standard guarantee conditions We, Electrolux, undertake that if within 12 months of the date of purchase this Electrolux appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair or replace the same FREE OF CHARGE for labour, materials or carriage on condition that: •...
Technical specifications DIMENSIONS POWER SUPPLY VOLTAGE AND FREQUENCY RATED CURRENT AVERAGE DAILY UNITS ELECTRICITY(*) GROSS CAPACITY NET CAPACITY STAR RATING (*)This figure is based on standard test results in accordance with European Standard EN153. Actual consumption will depend on how the appliance is used and where it is located. Installation Positioning This appliance should only be installed at a location...
Electrical Connection WARNING THIS APPLIANCE MUST BE EARTHED. The manufacturer declines any liability should this safety measure not be observed. If the plug that is fitted to your appliance is not suitable for your socket outlet, it must be cut off and the appropriate plug fitted.
Building-in instructions Before carrying out any work, remove the plug from the power socket. Grid preparation Left door opening: Remove the left side (A) of the grid cutting it from the rear (see figure). Right door opening: Remove the right side (B) of the grid cutting it from the rear (see figure).
Page 15
2. Push the appliance into place. The plug socket necessary for connection of the appliance to the electricity supply should be positioned, so that the plug is not placed in the recess. 3. To adjust the height proceed as follows: - Loosen or tighten the two front feet.
Page 16
° Upper part of kitchen furniture panel...
6. Refit the covering strip (A). Fitting the plinth Important For the efficient operation of the appliance, it is important that the original ventilation grid is used. • For an opening height dimension A=820 mm and a plinth height dimension a=100 mm, the plinth may be fitted without adjustments.