Securing The Access Point Using A Security Cable; Connecting The Ethernet And Power Cables - Cisco ASR1001 Hardware Installation Manual
Aironet 1000 series
Hide thumbs
Also See for ASR1001:
- Hardware installation manual (702 pages) ,
- Software configuration manual (378 pages) ,
- Common criteria operational user guidance and preparative procedures (72 pages)
Table of Contents
Advertisement
Chapter 2
Installing the Access Point
Securing the Access Point Using a Security Cable
You can secure the access point by installing a standard security cable (such as the Kensington MicroSaver,
model number 64068) into the access point security cable slot (see
used with any of the mounting methods described in this guide provided the cable can be secured to a
nearby immovable object.
Follow these steps to install the security cable.
Loop the security cable around a nearby immovable object.
Step 1
Insert the key into the security cable lock.
Step 2
Insert the security cable latch into the security key slot on the access point.
Step 3
Step 4
Rotate the key right or left to secure the security cable lock to the access point.
Step 5
Remove the key from security cable lock.
Step 6
Repeat Steps 1 to 4 for each access point requiring a security cable.
After securing your access points, go to the
Source" section on page
Connecting the Ethernet and Power Cables
The access point receives power through the Ethernet cable or an external power module.
Warning
This product must be connected to a Power over Ethernet (PoE) IEEE 802.3af compliant power source
or an IEC60950 compliant limited power source. Statement 353
Caution
This product and all interconnected equipment must be installed indoors within the same building,
including the associated LAN connections (as defined by Environment A of the IEEE 802.3af standard).
The access point power options:
•
•
•
OL-9403-04
2-18.
Option 1—Switches with sufficient inline power:
–
An inline power capable switch, such as the Cisco Catalyst 3550 PWR XL, 3560-48PS,
3750-48PS, 4500 with 802.3AF PoE module, or the 6500 with 802.3AF PoE module
–
Other inline power switches supporting the IEEE 802.3af inline power standard
Option 2—Switches without sufficient inline power can use the power injector:
–
Cisco Aironet Power Injector (AIR-PWRINJ-1000AF=)
Option 3—Local power using the power module (AIR-PWR-1000=)
Cisco Aironet 1000 Series Lightweight Access Point Hardware Installation Guide
Securing the Access Point Using a Security Cable
Figure
"Connecting to an Ethernet Network with an Inline Power
2-3). The security cable can be
2-17
Advertisement
Table of Contents
Troubleshooting
