HP A4500A - VMEbus Single Board Computer 744 Motherboard Special Instructions
Dc-to-dc converter replacement
Hide thumbs
Also See for A4500A - VMEbus Single Board Computer 744 Motherboard:
- Hardware manual (202 pages) ,
- Manual (114 pages) ,
- Programmer's manual (109 pages)
Advertisement
Quick Links
Download this manual
See also:
Manual
VRM Replacement for the rp24xx
This sheet contains instructions for replacement of the DC-to-DC Converters in the
server. These new DC-to-DC Converter modules are installed when new processors are
installed. The DC-to-DC Converters are replacements for the existing modules that
should be returned HP.
Special instructions concerning the DC-to-DC Converters are shipped in this upgrade kit.
Read and understand the instructions before installing the DC-to-DC Converters. When
you unpack the new DC-to-DC Converters, save the shipping carton and packing
materials. The old DC-to-DC Converters must be removed from the server and should be
returned to HP. Package the removed modules in the used packing materials and ship via
ground transportation.
Important Steps:
• The DC-to-DC Converter modules and the system board are Electrostatic
Discharge (ESD) sensitive and can be damaged during installation. Follow the
instructions in the ESD kit to ensure proper ESD procedures are used.
• Power is applied to server circuits even when the power switch is set to OFF.
Disconnect the power source before removing DC-to-DC Converters from server
connectors.
• Please return the old DC-to-DC Converter modules to HP. Refer to:
http://partpage.corp.hp.com/notes.asp?QRYSTR=NOTES&NTYPE=
PRODUCT&NSUBITEM=A5571A
for instructions and address.
Procedure:
Step 1. Turn off and disconnect power from the server.
WARNING Dangerous voltages may be present if power is
connected. For your protection, disconnect the server from the
power source before proceeding.
Step 2. Remove the top cover to allow access to the system board and internal
components.
Step 3. ESD precautions are important. Use the ESD wrist strap when touching server
components.
Step 4. Locate the master and slave DC-to-DC Converter modules to be removed.
DC-to-DC Converter Installation
5971-4258
Sep 2004
Advertisement
Related Manuals for HP A4500A - VMEbus Single Board Computer 744 Motherboard
Summary of Contents for HP A4500A - VMEbus Single Board Computer 744 Motherboard
- Page 1 VRM Replacement for the rp24xx DC-to-DC Converter Installation This sheet contains instructions for replacement of the DC-to-DC Converters in the server. These new DC-to-DC Converter modules are installed when new processors are installed. The DC-to-DC Converters are replacements for the existing modules that should be returned HP.
- Page 2 Master DC-DC Converter Slave Module Step 5. For the DC-to-DC Converter module to be removed: a. Gently pull the left and right levers away from each side of the board (approximately 0.635 cm - 1/4 in.). b. Grasp the module by the left and right edges. c.
- Page 3 Step 8. Install the top cover and reconnect power. Step 9. Place the removed DC-to- DC Converter modules in the used shipping materials and return to HP. Refer to: http://partpage.corp.hp.com/notes.asp?QRYSTR=NOTES&NTYPE= PRODUCT&NSUBITEM=A5571A for instructions. 5971-4258 Sep 2004...