HP Xw4600 - Workstation - 2 GB RAM Installation Manual
5.25-inch, half-height serial ata (sata) optical drive
Hide thumbs
Also See for Xw4600 - Workstation - 2 GB RAM:
- Technical reference manual (181 pages) ,
- Service and technical reference manual (176 pages) ,
- Specification (73 pages)
Table of Contents
Advertisement
Quick Links
SATA optical drive installation
This document describes how to install a standard 5.25-inch, half-height Serial ATA (SATA) optical drive
in your HP workstation.
Kit contents
●
13.335 cm (5.25 inch), half-height SATA optical drive
●
SATA interface cables
●
Four M3 guide screws
●
Optional application software CD (based on optical drive)
●
Warranty information
Tools required
●
T-15 Torx screwdriver
●
Flat-blade screwdriver
Before you begin
To view QuickSpecs and determine the compatibility of this product with your HP workstation, see
http://www.hp.com/go/productbulletin.
ENWW
© 2007–2009 Hewlett-Packard Development Company, L.P. Microsoft
Window XP and Windows Vista are U.S. registered trademarks of Microsoft
Corporation. Printed in the U.S.
Kit contents
1
Advertisement
Table of Contents
Related Manuals for HP Xw4600 - Workstation - 2 GB RAM
Summary of Contents for HP Xw4600 - Workstation - 2 GB RAM
-
Page 1: Kit Contents
Before you begin To view QuickSpecs and determine the compatibility of this product with your HP workstation, see http://www.hp.com/go/productbulletin. © 2007–2009 Hewlett-Packard Development Company, L.P. Microsoft Window XP and Windows Vista are U.S. registered trademarks of Microsoft Corporation. Printed in the U.S. -
Page 2: Warnings And Cautions
Warnings and cautions WARNING! Any surface or area of the equipment marked with this symbol indicates the presence of an electrical shock hazard. To reduce the risk of injury from electrical shock, do not open any enclosed area marked with this symbol. WARNING! To reduce the risk of electric shock or damage to your equipment: —... -
Page 3: Preparing For Component Installation
Preparing for component installation NOTE: Workstation models vary. All illustrations are examples only. Accessing the internal components of the workstation If you need help preparing the workstation for this installation, consult the removal and replacement procedures in the service guide for your workstation at http://www.hp.com/support/ workstation_manuals. - Page 4 If your optical drive requires guide screws, use the four M3 guide screws provided as part of the installation kit. Install two M3 guide screws into each side of the drive using a T-15 Torx screwdriver. NOTE: Some workstations, such as HP 600, 800, xw6600, xw8600, and xw9400 Workstations do not require guide screws.
- Page 5 Reassemble the workstation. Reinstall the front bezel, if applicable. Reinstall the expansion card support, if applicable. Reinstall the airflow guide, if applicable. Reinstall the side access panel. Reconnect power to the workstation and all external devices. Restore power to the workstation and all external devices. For information on operating your drive and enabling digital audio: ●...
-
Page 6: Regulatory Notices
Notice for Blu-ray optical drives If you installed a Blu-ray optical drive, note the following: Blu-ray movie playback As Blu-ray is a new format containing new technologies, certain disc, digital connection, compatibility and/or performance issues may arise, and do not constitute defects in the product. Flawless playback on all systems is not guaranteed.