Replacing The Heat Sink Assembly - Lenovo IdeaCentre K320 Hardware Replacement Manual
Lenovo ideacentre k320 hardware replacement guide v3.0
Hide thumbs
Also See for IdeaCentre K320:
- User manual (43 pages) ,
- Hardware maintenance manual (57 pages) ,
- Reference manual (49 pages)
Table of Contents
Advertisement
Replacing the heat sink assembly
Attention:
Do not remove the computer cover or attempt any repair before reading the
"Important safety information" in the Safety and Warranty Guide that was
included with your computer or in the Hardware Maintenance Manual (HMM)
for the computer. To obtain copies of the Safety and Warranty Guide or
HMM, go to the Support Web site at: http://consumersupport.lenovo.com
To replace the heat sink assembly:
1. Remove the computer cover. Refer to "Removing the computer cover".
2. Lay the computer on its side.
3. Locate the heat sink. Refer to "Identifying parts on the system board".
4. Disconnect the heat sink and the fan assembly cable from the system board.
5. Remove the four screws
system board.
6. Lift the failing heat sink and fan assembly off the system board.
7. Use the thermal grease syringe to place five drops of grease on the top of the
microprocessor. Each drop of grease should be 0.03ml (3 tick marks on the
grease syringe).
Hardware Replacement Guide
31041595_K3_HRG(H57)_EN_V3.0.ind18 18
securing the heat sink and fan assembly to the
2009.11.17 10:54:28 AM
Hide quick links:
Advertisement
Table of Contents
