Setting Up; Connecting Power; Cp5 Stage Piano; Cp50 Stage Piano - Yamaha CP5 Owner's Manual
Owner's manual
Hide thumbs
Also See for CP5:
- Reference manual (57 pages) ,
- Data list (42 pages) ,
- Brochure & specs (16 pages)
Table of Contents
Advertisement
Connecting Power
Setting Up
Connecting Power
CP5 Stage Piano:
1
Ensure that the
2
Insert the appliance end of the bundled power cord into the [AC IN] socket, also on the rear panel.
3
Plug the other end of the power cord into a domestic-use, AC wall socket.
NOTE
Carry out this procedure in reverse order when disconnecting the power cord.
WARNING
Use only the AC power cord supplied with the CP5. The use of an inappropriate replacement can pose a fire and shock hazard!
CAUTION
Make sure your CP5 meets the voltage requirement for the country or region in which it is being used. The power cord includes a
grounding pin to prevent electrical shock and damage to equipment. When connecting to an outlet, connect the adaptor's ground lead to
the ground screw. If you're unsure how to connect, then contact your Yamaha dealer or service center.
CAUTION
Even when the switch is in the OFF position, a small amount of electricity is still flowing to the unit. When you are not using the CP5 for
a long time, make sure to unplug the AC power adaptor from the wall AC outlet.
CP50 Stage Piano:
Connect the power adaptor that came with your CP50 as described below. Before doing so, ensure that the
On) switch is set to the Standby position.
1
Insert the power-adaptor plug into the DC IN connector on the CP50's rear panel.
2
Plug the power adaptor into a suitable AC wall socket.
NOTE
Carry out this procedure in reverse order when disconnecting the power adaptor.
WARNING
Use the specified adaptor (page 62) only on the CP50. Using the wrong adaptor can result in damage to the instrument or overheating.
WARNING
Make sure your CP50 is rated for the AC voltage supplied in the area in which it is to be used (as listed on the rear panel). Connecting the
unit to the wrong AC supply can cause serious damage to the internal circuitry and may even pose a shock hazard!
CAUTION
Even when the Standby/On switch is in the "Standby" position, electricity is still flowing to the instrument at the minimum level. When
you are not using the instrument for a long time, make sure you unplug the power cord from the wall AC outlet.
14
CP5/CP50 Owner's Manual
(Power) switch on the rear panel is set to the Off position.
[AC IN] socket
DC IN connector
(Standby/
- Quick Links:
- Rear Panel
- Changing Layer & Split Settings
Hide quick links:
Advertisement
Table of Contents
