Table of Contents
Advertisement
2.3.5.
SATA.1-4
While entering Setup, the BIOS automatically detects the presence of Serial ATA
devices. There is a separate sub-menu for each SATA device. Select a device item
then press <Enter> to display the SATA device information.
Main
Extended IDE Drive
Access Mode
Capacity
Cylinder
Head
Landing Zone
Sector
F1:Help
ESC: Exit
The BIOS automatically detects the values opposite the dimmed items (Capacity,
Cylinder, Head, Precomp, Landing Zone and Sector). These values are not user-
configurable. These items show 0 if no SATA device is installed in the system.
Extended Drive [Auto]
Selects the type of fixed disk connected to the system.
Configuration options: [None] [Auto]
Access Mode [Auto]
Sets the sector addressing mode. Configuration options: [Large] [Auto]
Before attempting to configure a hard disk drive, make sure you have the
correct configuration information supplied by the drive manufacturer. Incorrect
settings may cause the system to fail to recognize the installed hard disk.
Capacity
Displays the auto-detected hard disk capacity. This item is not configurable.
Cylinder
Shows the number of the hard disk cylinders. This item is not configurable.
2-18
Phoenix-Award BIOS CMOS Setup Utility
SATA 1
↑↓ : Select Item
→←: Select Menu
[Auto]
[Auto]
0 MB
0
0
0
0
-/+: Change Value
Enter: Select Sub-menu
Select Menu
Item Specific Help
Slects the type of fixed
disk connected to the
system.
F5: Setup Defaults
F10: Save and Exit
Chapter 2: BIOS setup
Hide quick links:
Advertisement
Table of Contents
