Table of Contents
Advertisement
Displaying IPv6 ACLs
This example shows how to apply the access list Cisco to outbound traffic on a Layer 3 interface:
Switch(config)# interface gigabitethernet 1/0/3
Switch(config-if)# no switchport
Switch(config-if)# ipv6 address 2001::/64 eui-64
Switch(config-if)# ipv6 traffic-filter CISCO out
Displaying IPv6 ACLs
You can display information about all configured access lists, all IPv6 access lists, or a specific access
list by using either or both of the privileged EXEC commands in
Table 36-1
Commands for Displaying IPv6 Access List Information
Command
show access-lists
show ipv6 access-list [access-list-name]
This is an example of the output from the show access-lists privileged EXEC command. The output
shows all access lists that are configured on the switch or switch stack.
Switch# show access-lists
Extended IP access list hello
IPv6 access list ipv6
This is an example of the output from the show ipv6 access-lists privileged EXEC command. The output
shows only IPv6 input and output access lists configured on the switch or switch stack.
Switch# show ipv6 access-list
IPv6 access list inbound
IPv6 access list outbound
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
36-8
10 permit ip any any
permit ipv6 any any sequence 10
permit tcp any any eq bgp (8 matches) sequence 10
permit tcp any any eq telnet (15 matches) sequence 20
permit udp any any sequence 30
deny udp any any sequence 10
deny tcp any any eq telnet sequence 20
Purpose
Display all access lists configured on the switch.
Display all configured IPv6 access lists or the access list specified by
name.
Chapter 36
Configuring IPv6 ACLs
Table
36-1.
OL-13270-06
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
