Disabling And Enabling Cdp On An Interface - Cisco IE-3000-8TC Software Configuration Manual
Software configuration guide
Hide thumbs
Also See for IE-3000-8TC:
- Command reference manual (802 pages) ,
- Administration manual (496 pages) ,
- Message manual (98 pages)
Table of Contents
Advertisement
Configuring CDP
Disabling and Enabling CDP on an Interface
CDP is enabled by default on all supported interfaces to send and to receive CDP information.
Beginning in privileged EXEC mode, follow these steps to disable CDP on a port:
Command
Step 1
configure terminal
Step 2
interface interface-id
Step 3
no cdp enable
Step 4
end
Step 5
copy running-config startup-config
Beginning in privileged EXEC mode, follow these steps to enable CDP on a port when it has been
disabled:
Command
Step 1
configure terminal
Step 2
interface interface-id
Step 3
cdp enable
Step 4
end
Step 5
copy running-config startup-config
This example shows how to enable CDP on a port when it has been disabled.
Switch# configure terminal
Switch(config)# interface gigabitethernet1/1
Switch(config-if)# cdp enable
Switch(config-if)# end
Cisco IE 3000 Switch Software Configuration Guide
28-4
Purpose
Enter global configuration mode.
Specify the interface on which you are disabling CDP, and enter
interface configuration mode.
Disable CDP on the interface.
Return to privileged EXEC mode.
(Optional) Save your entries in the configuration file.
Purpose
Enter global configuration mode.
Specify the interface on which you are enabling CDP, and enter
interface configuration mode.
Enable CDP on the interface after disabling it.
Return to privileged EXEC mode.
(Optional) Save your entries in the configuration file.
Chapter 28
Configuring CDP
OL-13018-03
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
