Configuring The Ip Slas Responder; Monitoring Ip Slas Operations - Cisco IE-3000-8TC Software Configuration Manual
Software configuration guide
Hide thumbs
Also See for IE-3000-8TC:
- Command reference manual (802 pages) ,
- Administration manual (496 pages) ,
- Message manual (98 pages)
Table of Contents
Advertisement
Monitoring IP SLAs Operations
Configuring the IP SLAs Responder
The IP SLAs responder is available only on Cisco IOS software-based devices, including some Layer 2
switches that do not support full IP SLAs functionality, such as the Catalyst 2960 or the Cisco ME 2400
or IE 3000 switch. Beginning in privileged EXEC mode, follow these steps to configure the IP SLAs
responder on the target device (the operational target):
Command
Step 1
configure terminal
Step 2
ip sla responder {tcp-connect |
udp-echo} ipaddress ip-address port
port-number
Step 3
end
Step 4
show ip sla responder
Step 5
copy running-config startup-config
To disable the IP SLAs responder, enter the no ip sla responder global configuration command. This
example shows how to configure the device as a responder for the UDP jitter IP SLAs operation in the
next procedure:
Switch(config)# ip sla responder udp-echo 172.29.139.134 5000
For the IP SLAs responder to function, you must also configure a source device, such as a Catalyst 3750
Note
or Catalyst 3560 switch running the IP services image, that has full IP SLAs support. Refer to the
documentation for the source device for configuration information.
Monitoring IP SLAs Operations
Use the User EXEC or Privileged EXEC commands in
configuration.
Table 35-1
Monitoring IP SLAs Operations
Command
show ip sla authentication
show ip sla responder
Cisco IE 3000 Switch Software Configuration Guide
35-6
Purpose
Enter global configuration mode.
Configure the switch as an IP SLAs responder.
The optional keywords have these meanings:
tcp-connect—Enable the responder for TCP connect operations.
•
udp-echo—Enable the responder for User Datagram Protocol (UDP)
•
echo or jitter operations.
ipaddress ip-address—Enter the destination IP address.
•
port port-number—Enter the destination port number.
•
The IP address and port number must match those configured on
Note
the source device for the IP SLAs operation.
Return to privileged EXEC mode.
Verify the IP SLAs responder configuration on the device.
(Optional) Save your entries in the configuration file.
Purpose
Display IP SLAs authentication information.
Display information about the IP SLAs responder.
Chapter 35
Configuring Cisco IOS IP SLAs Operations
Table 35-1
to display IP SLAs operations
OL-13018-03
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
