Chapter 5: Setting Up The Wap4410N Wireless-N Access Point; Launching The Web-Based Configuration Utility - Cisco WAP4410N - Small Business Wireless-N Access Point Administration Manual

Wireless-n access point with power over ethernet

Hide thumbs Also See for WAP4410N - Small Business Wireless-N Access Point:

Table of Contents

Setting Up the WAP4410N Wireless-N Access

Point

STEP 1

STEP 2

WAP4410N Wireless-N Access Point with Power Over Internet

The WAP4410N Access Point works right out of the box with the default settings.

However, you can change these settings to suit your needs by accessing the

access point using a web-based configuration utility.

The firmware v2.0.0.5 or later releases changed the factory default IP address

configuration to DHCP. Before installation, make sure your DHCP server is running

and can be reached. You may need to disconnect and reconnect the devices for

them to discover their new IP addresses from the DHCP server.

If the WAP4410N access point does not receive a DHCP response after 60

seconds, it falls back to the following default static IP address: 192. 1 68. 1 .245 and a

default mask of 255.255.255.0. For firmware releases earlier than v2.0.0.5, the

static IP address is 192. 1 68. 1 .245.

To configure the WAP4410N Access Point, follow these steps to access the

WAP4410N web-based configuration utility from your computer.

Connect the WAP4410N Access Point to the same network as your computer.

Locate the IP address of the WAP4410N Access Point by accessing your DHCP

server. Specific instructions on locating the DHCP address given to the

WAP4410N Access Point depends upon the type of architecture and operating

NOTE: Make sure you have Enabled TCP/IP

on your computers prior to proceeding.

Computers communicate over the network with

this protocol.

Table of Contents

Show Quick Links

Table of Contents