Table of Contents
Advertisement
Mounting to a Network Cable Box
Repeat Steps 1 and 2 to install the second box hanger on the right side of the mounting bracket. Refer to
Step 3
Figure
Figure 2-13
Perform Steps 3 through 16 in the
Step 4
Mounting to a Network Cable Box
Follow these steps to mount the access point on a network cable box.
Position the mounting plate over the network cable box and align the appropriate mounting holes (See
Step 1
Figure
Hold the mounting plate and insert two or 4 #6 or #8 pan head screws (to match network box
Step 2
configuration) through the mounting plate and into the corresponding threaded holes of the network box.
Pull the access point cables out of the network box until there is about 1 foot of exposed cables
Step 3
protruding from the box.
Attach the access point to the mounting plate (see the
Step 4
section on page
Cisco Aironet 1250 Series Access Point Hardware Installation Guide
2-18
Figure
2-13.
Securing the Right Side Mounting Clip to the Mounting Bracket
2-2) with the holes of your specific network box.
2-24).
"Installing Option One" section on page
"Installing the Access Point to the Mounting Plate"
Chapter 2
Installing the Access Point
2-13.
OL-8247-03
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
