Replacing The Chassis Cover - Cisco IPS-4240-K9 - Intrusion Protection Sys 4240 Installation Manual
Intrusion prevention system appliances and modules 5.0
Hide thumbs
Also See for IPS-4240-K9 - Intrusion Protection Sys 4240:
- Installation instructions manual (14 pages) ,
- Getting started manual (12 pages)
Table of Contents
Advertisement
Chapter 3
Installing IDS-4215
Replacing the Chassis Cover
Caution
Do not operate IDS-4215 without the chassis cover installed. The chassis cover protects the internal
components, prevents electrical shorts, and provides proper air flow for cooling the electronic
components.
To replace the chassis cover, follow these steps:
Step 1
Place the chassis on a secure surface with the front panel facing you.
Step 2
Hold the top panel so the tabs at the rear of the top panel are aligned with the chassis bottom.
Step 3
Lower the front of the top panel onto the chassis, making sure that the top panel side tabs fit under the
chassis side panels.
Step 4
Slide the top panel toward the front, making sure that the top panel tabs fit under the chassis back panel
and the back panel tabs fit under the top panel.
78-16124-01
POWER
ACT
NETWORK
POWER
ACT
NETWORK
Installing Cisco Intrusion Prevention System Appliances and Modules 5.0
Removing and Replacing the Chassis Cover
CISCO IDS-4215
Intrusion Detection Sensor
CISCO IDS-4215
Intrusion Detection Sensor
3-13
Hide quick links:
Advertisement
Table of Contents
