Removing Nm-Cids Using Oir Support - Cisco IPS-4240-K9 - Intrusion Protection Sys 4240 Installation Manual
Intrusion prevention system appliances and modules 5.0
Hide thumbs
Also See for IPS-4240-K9 - Intrusion Protection Sys 4240:
- Installation instructions manual (14 pages) ,
- Getting started manual (12 pages)
Table of Contents
Advertisement
Chapter 8
Installing NM-CIDS
Loosen the two captive screws holding NM-CIDS in the chassis slot.
Step 4
ETHE RNET 0
Step 5
Slide NM-CIDS out of the slot.
Note
Removing NM-CIDS Using OIR Support
Cisco 3660 and Cisco 3700 series routers support OIR with similar modules only. If you remove an
Caution
NM-CIDS, install another NM-CIDS in its place.
To remove NM-CIDS with OIR support, follow these steps:
Prepare NM-CIDS to be powered off:
Step 1
router# service-module IDS-Sensor slot_number/0 shutdown
Trying 10.10.10.1, 2129 ... Open
Wait for the shutdown message before continuing with Step 2:
%SERVICEMODULE-5-SHUTDOWN2:Service module IDS-Sensor1/0 shutdown complete
Unplug the command and control network interface cable from NM-CIDS.
Step 2
78-16124-01
WO
SERIA L
ASY NC
15
11
ASYN C 24-31
14
10
7
13
9
6
12
8
5
4
15
11
ASYN C 8-15
14
10
7
13
9
6
12
8
5
4
Network module
Either install a replacement NM-CIDS (for the procedure, see
page
8-6) or install a blank panel (for the procedure, see
page
8-11).
Installing Cisco Intrusion Prevention System Appliances and Modules 5.0
3
ASYN C 16-23
2
1
0
3
ASYN C 0-7
2
1
0
EN
Installation and Removal Instructions
Router
Installing NM-CIDS Offline,
Blank Network Module Panels,
8-10
Hide quick links:
Advertisement
Table of Contents
