Removing A Power Supply - Cisco WS-X6148-GE-TX - Switch Hardware Installation Manual

Ucs 6100 series fabric interconnect

Hide thumbs Also See for WS-X6148-GE-TX - Switch:

Table of Contents

Chapter 2

Installing the Cisco UCS 6100 Series Fabric Interconnect

S e n d d o c u m e n t c o m m e n t s t o u c s - d o c f e e d b a c k @ c i s c o . c o m

You can replace a faulty power supply while the system is operating provided the other power supply is

Note

functioning.

This section includes the following topics:

•

Removing a Power Supply

Caution

If you are using the Cisco UCS 6100 Series Fabric Interconnect with one power supply, removing the

power supply causes the system to shut down. If you are using two power supplies and you remove one

of them, the system continues to operate.

To remove a power supply, follow these steps:

Step 1

Ensure that the system (earth) ground connection has been made. For ground connection instructions,

see the

Step 2

Grasp the power supply handle with your left hand.

OL-20036-02

Removing a Power Supply, page 2-25

Installing a Power Supply, page 2-26

"Grounding the System" section on page

2-11.

Cisco UCS 6100 Series Fabric Interconnect Hardware Installation Guide

Replacing or Installing Components

2-25

Table of Contents

Show Quick Links

Table of Contents