Connection Procedures And Precautions; Connecting To A Console Terminal Or Modem; Connecting To The Console Port With Microsoft Windows; Connecting To The Console Port With Linux - Cisco WS-C1924-A - Catalyst 1900 24 Ports 10MB Switch Hardware Installation Manual
1900 series integrated services router
Table of Contents
Advertisement
Connecting to a Console Terminal or Modem
Connection Procedures and Precautions
Connect each WAN and LAN cable to the appropriate connector on the chassis or interface card.
•
•
•
•
For cable pinouts, refer to
Connecting to a Console Terminal or Modem
Your router has asynchronous serial, USB, console, and auxiliary ports. These ports provide
administrative access to your router either locally (with a console terminal or PC) or remotely (with a
modem).
The following cables and adapters may be used for connecting your router to a console terminal, PC, or
modem:
•
•
•
The first time a Windows-based PC is connected to the router, a USB device driver must be installed.
Note
See the
This section describes how to connect a console terminal or PC to the console port and how to connect
a modem to the auxiliary port.
•
•
•
Connecting to the Console Port with Microsoft Windows
To configure the router through the Cisco IOS command-line interface (CLI), you must connect the
router console port to a terminal or PC. See the
page
A Microsoft Windows PC must have HyperTerminal or similar terminal emulation software installed.
The software should be configured with the following parameters: 9600 baud, 8 data bits, no parity, 1
stop bit, and no flow control. Refer to the Cisco 3900 Series, 2900 Series, and 1900 Series Software
Configuration Guide for detailed information about using Cisco IOS software for configuring the router.
Cisco 1900 Series Hardware Installation
4-14
Position the cables carefully, so that they do not put strain on the connectors.
Organize the cables in bundles so that cables do not intertwine.
Inspect the cables to make sure that the routing and bend radiuses are satisfactory. Reposition the
cables, if necessary.
Install cable ties in accordance with your site requirements.
Cisco Modular Access Router Cable
USB console cable—USB 5-pin mini Type-B to USB Type-A. See the
on page 3-2
for port details and the
Console cable— EIA RJ-45 to DB-9
Modem adapter—DB-9 to DB-25
"Installing the Cisco Microsoft Windows USB Device Driver" section on page
Connecting to the Console Port with Microsoft Windows, page 4-14
Connecting to the Console Port with Mac OS X, page 4-16
Connecting to the Console Port with Linux, page 4-16
3-1.
Chapter 4
Specifications.
"Specifications" section on page
"Console and Auxiliary Port Considerations" section on
Installing and Connecting the Router
"USB Serial Console" section
1-14.
4-17.
OL-19084-02
Hide quick links:
Advertisement
Table of Contents
