Table of Contents
Advertisement
Chapter 1
Product Overview
Figure 1-3
S T A N D B
1
When you want to connect additional devices, press the Standby/Active button to
place the RPS in standby mode. The Standby/Active LED flashes amber. When
you have connected and powered up all devices, press the Standby/Active button
again to put the RPS into active mode.
When the RPS is in standby mode, all of the DC Output LEDs are amber.
Note
When the RPS is in standby mode, the RPS LED that is on the connected device
Note
is amber; this means that the RPS is connected but is not functioning. When you
press the Standby/Active button, the RPS LED that is on the connected device
changes to green to show that the RPS is operating properly.
78-15201-04
Standby/Active Button
S T A N D B
Y /A C T IV
E
O U T P U
T P W R
T E M P
1
F A N
Y /A C T IV
E
1
Standby/Active button
Cisco RPS 675 Redundant Power System Hardware Installation Guide
D C O U T
P U T
2
3
4
Front-Panel Description
5
6
1-7
Hide quick links:
Advertisement
Table of Contents
