Initial Configuration Using The Setup Command Facility - Cisco 3845 - Security Bundle Router Quick Start Manual
3800 series security bundle router
Hide thumbs
Also See for 3845 - Security Bundle Router:
- Software manual (956 pages) ,
- Manual (94 pages) ,
- Hardware installation manual (418 pages)
Table of Contents
Advertisement
If the messages above do not appear, SDM and the Cisco Router and Security Device Manager (SDM) Quick Start Guide
Tip
were not shipped with your router. If you want to use SDM, you can download the latest version of SDM and
instructions for installing it on your router from the following location:
http://www.cisco.com/pcgi-bin/tablebuild.pl/sdm
To obtain the SDM quick start guide, SDM release notes, and other SDM documentation, go to www.cisco.com/go/sdm
and click the Technical Documentation link.
Initial Configuration Using the Setup Command Facility
This section shows how to use the setup command facility to configure a hostname for the router, set passwords, and configure
an interface for communication with the management network. If the following messages appear at the end of the startup
sequence, the setup command facility has been invoked automatically:
--- System Configuration Dialog ---
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Would you like to enter the initial configuration dialog? [yes/no]:
The setup command facility prompts you for basic information about your router and network, and it creates an initial
configuration file. After the configuration file is created, you can use the CLI or Cisco Router and Security Device Manager
(SDM) to perform additional configuration.
The prompts in the setup command facility vary depending on your router model, the installed interface modules, and the
software image. The following example and the user entries (in
For help with interface and port numbering, see the "Port Numbering" section on page 29.
If you make a mistake while using the setup command facility, you can exit and run the setup command facility again.
Note
Press Ctrl-C, and type setup at the privileged EXEC mode prompt (Router#).
To proceed using the setup command facility, enter yes when the power-up messages have ended.
Step 1
Would you like to enter the initial configuration dialog? [yes/no]: yes
When the following messages appear, press Return to enter basic management setup:
Step 2
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Basic management setup configures only enough connectivity
for management of the system, extended setup will ask you
to configure each interface on the system
Would you like to enter basic management setup? [yes/no]: yes
Enter a hostname for the router (this example uses Router):
Step 3
Configuring global parameters:
Enter host name [Router]: Router
Step 4
Enter an enable secret password. This password is encrypted (more secure) and cannot be seen when you view the
configuration.
The enable secret is a password used to protect access to
privileged EXEC and configuration modes. This password, after
) are shown as examples only.
bold
31
Hide quick links:
Advertisement
Table of Contents
