Configuring Rspan - Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual

Catalyst 6000 series software configuration guide

Hide thumbs Also See for WS-X6066-SLB-APC - Content Switching Module:

Table of Contents

Configuring RSPAN

Admin Source

Incoming Packets: enabled

Console> (enable)

This example shows how to set port 3/2 as the SPAN source and port 2/2 as the SPAN destination:

Console> (enable) set span 3/2 2/2 tx create

Admin Source

Incoming Packets: disabled

Admin Source

Incoming Packets: disabled

Console> (enable)

To disable SPAN, perform this task in privileged mode:

Disable SPAN on the switch.

This example shows how to disable SPAN on the switch:

Console> (enable) set span disable 2/1

This command will disable your span session.

Do you want to continue (y/n) [n]?y

Disabled port 2/1 to monitor transmit traffic of VLAN 522

Console> (enable)

Configuring RSPAN

These sections describe how to configure RSPAN:

Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4

: Port 2/1-2

: transmit/receive

RSPAN Hardware Requirements, page 38-9

Understanding How RSPAN Works, page 38-9

RSPAN Configuration Guidelines, page 38-10

Configuring RSPAN, page 38-11

RSPAN Configuration Examples, page 38-14

Configuring SPAN and RSPAN

set span disable [dest_mod/dest_port | all]

Show Quick Links

Table of Contents