Searching And Filtering Output Of Show And More Commands; Accessing The Cli; Opening The Cli With Telnet - Cisco Aironet AIR-AP1200 Hardware Installation Manual
Aironet 1200 series access point
Hide thumbs
Also See for Aironet AIR-AP1200:
- Hardware installation manual (138 pages) ,
- User manual (36 pages) ,
- Ordering manual (6 pages)
Table of Contents
Advertisement
Searching and Filtering Output of show and more Commands
After you complete the entry, press Ctrl-A to check the complete syntax before pressing the Return key
to execute the command. The dollar sign ($) appears at the end of the line to show that the line has been
scrolled to the right:
ap(config)# access-list 101 permit tcp 131.108.2.5 255.255.255.0 131.108.1$
The software assumes you have a terminal screen that is 80 columns wide. If you have a width other than
that, use the terminal width privileged EXEC command to set the width of your terminal.
Use line wrapping with the command history feature to recall and modify previous complex command
entries. For information about recalling previous command entries, see the
Keystrokes" section on page
Searching and Filtering Output of show and more Commands
You can search and filter the output for show and more commands. This is useful when you need to sort
through large amounts of output or if you want to exclude output that you do not need to see.
To use this functionality, enter a show or more command followed by the pipe character (|), one of the
keywords begin, include, or exclude, and an expression that you want to search for or filter out:
command | {begin | include | exclude} regular-expression
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
are not displayed, but the lines that contain Output are displayed.
This example shows how to include in the output display only lines where the expression protocol
appears:
ap# show interfaces | include protocol
Vlan1 is up, line protocol is up
Vlan10 is up, line protocol is down
GigabitEthernet0/1 is up, line protocol is down
GigabitEthernet0/2 is up, line protocol is up
Accessing the CLI
You can open the access point's CLI using Telnet or Secure Shell (SSH).
Opening the CLI with Telnet
Follow these steps to open the CLI with Telnet. These steps are for a PC running Microsoft Windows
with a Telnet terminal application. Check your PC operating instructions for detailed instructions for
your operating system.
Select Start > Programs > Accessories > Telnet.
Step 1
If Telnet is not listed in your Accessories menu, select Start > Run, type Telnet in the entry field, and
press Enter.
When the Telnet window appears, click Connect and select Remote System.
Step 2
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
5-8
5-6.
Chapter 5
Using the Command-Line Interface
"Editing Commands Through
OL-4310-05
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
