Table of Contents
Advertisement
Chapter 3
Configuring the Access Point for the First Time
•
Click Apply to save your settings. If you changed the IP address, you lose your connection to the access
Step 7
point. Browse to the new IP address to reconnect to the access point.
Your access point is now running but probably requires additional configuring to conform to your
network's operational and security requirements. Consult the chapters in this manual for the information
you need to complete the configuration.
Note
Default Settings on the Express Setup Page
Table 3-1
Table 3-1
Setting
System Name
Configuration Server Protocol
IP Address
IP Subnet Mask
Default Gateway
Radio Service Set ID (SSID)
Broadcast SSID in Beacon
Role in Radio Network
Optimize Radio Network for
Aironet Extensions
SNMP Community
1. When you assign multiple SSIDs, this setting no longer appears.
OL-4309-02
SNMP Community—If your network is using SNMP, enter the SNMP Community name provided
by your network administrator and select the attributes of the SNMP data (also provided by your
network administrator).
You can restore the access point to its factory defaults by unplugging the power jack and
plugging it back in while holding down the Mode button for a few seconds, or until the Status
LED turns amber.
lists the default settings for the settings on the Express Setup page.
Default Settings on the Express Setup Page
Default
ap
DHCP
Assigned by DHCP by default; if
DHCP is disabled, the default
setting is 10.0.0.1
Assigned by DHCP by default; if
DHCP is disabled, the default
setting is 255.255.255.224
Assigned by DHCP by default; if
DHCP is disabled, the default
setting is 0.0.0.0
tsunami
1
Yes
Access point (root)
Throughput
Enable
defaultCommunity
Cisco Aironet 1100 Series Access Point Hardware Installation Guide
Assigning Basic Settings
3-7
Hide quick links:
Advertisement
Table of Contents
