Table of Contents
Advertisement
Chapter 3
Installing the Clean Access Manager and Clean Access Server
Install the Clean Access Manager (CAM) Software from CD-ROM
The following steps describe how to perform optional CD installation of the Clean Access Manager
software on the NAC-3310/3315 MANAGER, NAC-3350/3355 MANAGER, and NAC-3390/3395
MANAGER appliances.
Connect the target installation machine to the network and access the command line of the machine by
Step 1
direct console or over a serial connection, as described in
page
Step 2
Download the latest software version supported on the target machine as follows:
a.
b.
c.
Insert the CD-ROM containing the Cisco NAC Appliance .ISO file into the CD-ROM drive and reboot
Step 3
the machine.
The Cisco Clean Access Installer welcome screen appears after the machine restarts:
Step 4
Cisco Clean Access 4.8.3 Installer (C) 2012 Cisco Systems, Inc.
-
-
t the boot prompt and press the <ENTER> key.
boot:
At the "
Step 5
•
•
If the install CD detects an existing installation of Cisco NAC Appliance, you are presented with the
Step 6
following prompt:
Checking for existing installations.
Clean Access Manager 4.8.0 installation detected.
Please choose one of the following actions:
1) Install.
2) Exit.
Choose
Step 7
OL-20326-01
3-39.
Log in to the Cisco Software Download Site at http://www.cisco.com/public/sw-center/index.shtml.
You will likely be required to provide your CCO credentials.
Navigate to Security > Endpoint Security > Cisco Network Access Control > Cisco NAC
Appliance > Cisco NAC Appliance 4.8.
Download the latest 4.8(x) .ISO image (e.g. nac-4.8_3-K9.iso) and burn the image as a bootable
disk to a CD-R.
Cisco recommends burning the .ISO image to a CD-R using speeds 10x or lower. Higher
Note
speeds can result in corrupted/unbootable installation CDs.
Welcome to the Cisco Clean Access Installer!
To install a Cisco Clean Access device, press the <ENTER> key.
To install a Cisco Clean Access device over a serial console, enter serial a
:" prompt, type one of the following options depending on the type of connection:
boot
Press the Enter key if your monitor and keyboard are directly connected to the appliance.
Type
and press enter in the terminal emulation console if you are accessing the appliance
serial
over a serial connection.
to perform a fresh installation of the Cisco NAC Appliance software.
1
Installing the Clean Access Manager
Serial Connection to the CAM and CAS,
Cisco NAC Appliance Hardware Installation Guide
3-5
Hide quick links:
Advertisement
Table of Contents
