Table of Contents
Advertisement
Chapter 2 Catalyst 2350 Cisco IOS Commands
SW
PID
--
------------------
1
Built-in
This is an example of output from the show env power command on a switch:
Switch> show env power
SW
PID
--
------------------
1
Built-in
This example shows how to display the temperature value, state, and the threshold values on a switch .
Table 2-16
Switch> show env temperature status
Temperature Value: 42 Degree Celsius
Temperature State: GREEN
Yellow Threshold : 49 Degree Celsius
Red Threshold
Table 2-16
State
Green
Yellow
Red
OL-19055-01
Serial#
----------
Serial#
----------
describes the temperature states in the command output.
: 69 Degree Celsius
States in the show env temperature status Command Output
Description
The switch temperature is in the normal operating range.
The temperature is in the warning range. You should check the external temperature
around the switch.
The temperature is in the critical range. The switch might not run properly if the
temperature is in this range.
Status
Sys Pwr
---------------
-------
Good
Status
Sys Pwr
---------------
-------
Good
Catalyst 2350 Switch Command Reference
show env
PoE Pwr
Watts
-------
-----
PoE Pwr
Watts
-------
-----
2-261
Advertisement
Chapters
Table of Contents
