Whirlpool WFO 3T233 P 6.5 X Quick Manual

Hide thumbs

page of 20

/ 20
Bookmarks

Quick Links

Download this manual

Quick Guide

THANK YOU FOR BUYING A WHIRLPOOL PRODUCT.

In order to receive a more complete assistance, please

Before using the appliance carefully read the Safety Instruction.

CONTROL PANEL

On-Off/Reset button with indicator light

Program selection button with indicator light

Multizone button with indicator light

Turbo button with indicator light / Key lock

Eco program indicator light

Key lock indicator light

Display

Program number and remaining time

indicator

FIRST TIME USE

FILLING THE SALT RESERVOIR

The use of salt prevents the formation of LIMESCALE on the dishes and on

the machine's functional components.

• It is mandatory that the salt reservoir never be empty.

• It is important to set the water hardness.

The salt reservoir is located in the lower part of the dishwasher and must be

filled when the SALT REFILL indicator light

1. Remove the lower rack and unscrew the reservoir cap

(anticlockwise).

2. Position the funnel (see figure) and fill the salt reservoir

right up to its edge (approximately 1 kg); it is not unu-

sual for a little water to leak out.

3. Only the first time you do this: fill the salt reservoir

with water.

4. Remove the funnel and wipe any salt residue away from the opening.

Make sure the cap is screwed on tightly, so that no detergent can get into

the container during the wash program (this could damage the water

softener beyond repair).

Whenever you need to add salt, it is mandatory to complete the proce-

dure before the beginning of the washing cycle to avoid corrosion.

WATER SOFTENING SYSTEM

Water softener automatically reduces water hardness, consequently pre-

venting scale buildup on heater, contributing also to better cleaning effi-

ciency. This system regenerates itself with salt, therefore it is required

PROGRAMS TABLE

Program

Eco 50°- Program is suitable to clean normally soiled tableware, that for

this use, it is the most efficient programme in terms of its combined ener-

gy and water consumption, and that it is used to assess compliance with

the EU Ecodesign legislation.

Sense® 50°- 60°- For normally soiled dishes with dried food residues. Sen-

ses the level of soiling on the dishes and adjusts the program accordingly.

Intensive 65° - Program recommended for heavily soiled crockery, espe-

cially suitable for pans and saucepans.

Fast Wash&Dry 50° - Normally soiled crockery. Everyday cycle, that ensu-

res optimal cleaning and drying performance in shorter time.

Crystals 45° - Program for delicate items, which are more sensitive to high

temperatures, for example glasses and cups.

Rapid 30' 50° - Program to be used for half load of lightly-soiled dishes

with no dried food residues. Without drying.

Silent 50° - Suitable for night-time operation of the appliance. With the

lowest noise.

Sanitizing 65°- Normally or heavily soiled crockery, with additional anti-

bacterial wash. Can be used to perform maintenance of the dishwasher

Prewash - Use to refresh crockery planned to be washed later. No deter-

gent to be used with this program.

Self- Clean 65°- Program to be used to perform maintenance of the

10.

dishwasher, to be carried out only when the dishwasher is EMPTY using

specific detergents designed for dishwasher maintenance.

ECO program data is measured under laboratory conditions according to European Standard EN 60436:2020. Note for Test Laboratories: For information on com-

parative EN testing conditions, please send an email to the following address: dw_test_support@europeanappliances.com

Pre-treatment of the dishes is not needed before any of the programs.

*) Not all options can be used simultaneously.

**) Values given for programs other than the program Eco are indicative only. The actual time may vary depending on many factors such as temperature and

pressure of the incoming water, room temperature, amount of detergent, quantity and type of load, load balancing, additional selected options and sensor cali-

bration. The sensor calibration can increase program duration up to 20 min.

WATER RECYCLING INDICATOR - When lit, it indicates that standard program uses water recycling system.

Tablet (Tab) indicator light

10. Closed water tap indicator

light

11. Rinse Aid refill indicator

light

12. Salt refill indicator light

13. Power Clean® button with

indicator light

14. Tablet button with indicator light

in the control panel is lit.

Programs description

PLEASE SCAN THE QR CODE ON YOUR

APPLIANCE IN ORDER TO HAVE MORE

DETAILED INFORMATION

15. Delay button with indicator light

16. Start/Pause button with indicator light /

to refill salt container when empty.

Frequency of regeneration depends on water hardness level setting - regen-

eration takes place once per 8 Eco cycles with water hardness level set to 3.

Regeneration process starts in final rinse and finishes in drying phase, be-

fore cycle ends.

• Single regeneration consumes: ~3.5L of water;

• Takes up to 5 additional minutes for the cycle;

• Consumes below 0.005kWh of energy.

FILLING THE RINSE AID DISPENSER

Rinse aid makes dish DRYING easier. The rinse

aid dispenser A should be filled when the

RINSE AID REFILL indicator light

control panel is lit.

NEVER pour the rinse aid directly into the

appliance tub.

FILLING THE DETERGENT DISPENSER

To open the detergent dispenser use the opening device C. Introduce the

detergent into the dry dispenser D only. Place the amount of detergent for

pre-washing directly inside the tub.

If all-in-one detergents are used, we recommend using the TABLET button,

because it adjusts the program so that the best washing and drying results

are always achieved.

Usage of detergent not designed for dishwashers may cause

malfunction or damage to the appliance.

Available

options

7 8

1112

Drain out

Water

Duration

con-

of wash

sumption

program

(litres/

(h:min)

**)

cycle)