Advertisement
Quick Links
Operating Instructions
_ Bedienungsanleftung
Mode d'emploi_
_ Istruzioni per fuso
English;
Page 1
Deutsch;
Seite 17
Francais;
Page 33
Italiano;
Pag. 49
Thank you for buying this Pioneer product.
The differences between the models are given below.
HEM
model:
For Europe excluding U.K. ('HEM' stamped on packing case): A
2-Point (220 V/240 V) voltage selector switch is provided.
HB model:
For U.K. ('HB' stamped on packing case): A 2-Point (220 V/240 V)
voltage selector switch is provided.
HP model:
For Australia ('HP' stamped on packing case): Power line voltage is
AC 240 volts.
KU and KC models:
For U.S.A. and Canada ('KU' or 'KC' stamped on packing case):
Power line voltage is AC 120 volts.
S and S/G models:
For destinations excluding above ('S' or 'S/G' stamped on packing
case): A 4-point (110 V/120 V/220 V/240 V) voltage selector switch is
provided.
NOTE:
Depending upon the model, the design of the power site and the
power outlet differs.
The line voltage selector switch is located on the rear panel of the
unit. Please check that it is set properly before plugging the power
cord into an outlet.
STEREO DOUBLE CASSETTE TAPE DECK
STEREO-DOPPELKASSETTENDECK
MAGNETOPHONE
DOUBLE CASSETTE STEREO
DOPPIA PIASTRA DI REGISTRAZIONE
NOTE:
The photograph and illustration are for the C 7-O55W.
However,
the description also applies to the CT-1050W.
IMPORTANT NOTICE (For KU and KC models)
The serial number for this equipment is located on the rear panel.
Please write this serial number on your enclosed warranty card and
keep in a secure place: This is for your security.
WARNING:
TO PREVENT
FIRE OR
SHOCK HAZARD, DO NOT EXPOSE
THIS
APPLIANCE
TO
RAIN
OR
MOISTURE.
LINE VOLTAGE SELECTION
(S and S/G models only)
Before your model is shipped from the factory, the switch Is set to the
power
requirements
of the destination;
nevertheless,
you
should
check that it is set properly before plugging the power cord into the
AC outlet.
1. Disconnect the power cord.
2. Provide yourself with a medium size screwdriver.
3. Insert the screwdriver into the groove on the voltage selector and
adjust to the voltage value of your area.
VOLTAGE SELECTOR
Advertisement
