Cisco 2620 Configuration Manual page 121
Software configuration guide
Hide thumbs
Also See for 2620:
- Operations (25 pages) ,
- User manual (92 pages) ,
- Hardware installation manual (104 pages)
Table of Contents
Advertisement
Chapter 3
Configuring with the Command-Line Interface
Step 7
Step 8
Step 9
Step 10
Step 11
Step 12
Step 13
OL-1957-04
Command
Router(config-if-vc)#
encapsulation {aal1 | aal2 |
aal5ciscoppp | aal5mux |
aal5nlpid | aal5snap}
Router(config-if-vc)# exit
Router(config-if)# dsl
operating-mode {gshdsl
symmetric annex {A | B}
Router(config-if)#
equipment-type {co | cpe}
Router(config-if)# dsl linerate
{kbps | auto }
Router(config-if)# exit
Router(config)# exit
Software Configuration Guide for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers
Configuring 1-Port G.SHDSL WAN Interface Card
Purpose
(Optional) Configures the ATM adaptation layer (AAL)
and encapsulation type.
•
aal1—AAL1
•
aal2—AAL2
•
aal5ciscoppp—Cisco PPP over AAL5
•
aal5mux—AAL5+MUX
•
aal5nlpid—AAL5+NLPID
•
aal5snap—AAL5+LLC/SNAP (the default)
Exits from interface-atm-vc configuration mode.
Configures the DSL interface to operate in a specified
DSL mode:
•
gshdsl—Configures multirate, high-speed DSL per
ITU G.991.2
•
symmetric—Configures symmetrical mode per
•
ITU G.992.1.
•
annex—Configures the regional operating
parameters.
•
A—Sets the operating parameters for
North America. This value is the default.
•
B—Sets the operating parameters for Europe.
The default is gshdsl symmetric annex A
Configures the DSL interface to function as central
office equipment or customer premises equipment:
•
co—The WIC functions as central office equipment
and can interface with another G.SHDSL WIC
configured as cpe.
•
cpe—The WIC functions as customer premises
equipment and can interface with a DSLAM or with
another G.SHDSL WIC configured as co.
The default is cpe.
Configures the DSL line rate:
•
kbps—Line rate (data transfer rate) in kilobits per
second. Allowable entries are 72, 136, 200, 264,
392, 520, 776, 1032, 1160, 1544, 2056, and 2312.
•
auto—The WIC automatically trains for an optimal
line rate by negotiating with the far-end DSLAM or
WIC.
The default is auto.
Exits from ATM interface configuration mode.
Exits from global configuration mode.
3-61
- Quick Links:
- Cisco 2600 Series Interface Numbering
Hide quick links:
Advertisement
Chapters
Table of Contents
