Tdm Cross-Connect - Cisco 2431 - IAD Router Software Configuration Manual
Integrated access devices
Hide thumbs
Also See for 2431 - IAD Router:
- System message manual (106 pages) ,
- Hardware installation manual (88 pages)
Table of Contents
Advertisement
Chapter 3
Configuring with the Command-Line Interface
The serial interface must be a DTE device.
Note
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
7.
8.
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router# enable
Step 2
configure terminal
Example:
Router# configure terminal
Step 3
tdm-group tdm-group-no timeslot timeslot-list
Example:
Router(config-controller)# tdm-group 1 timeslot
13-20
Step 4
exit
Example:
Router(config-controller)# exit
Step 5
interface type number
Example:
Router(config-controller)# interface serial 1/0:0
Step 6
no keepalive
Example:
Router(config-if)# no keepalive
OL-4306-03
enable
configure terminal
tdm-group tdm-group-no timeslot timeslot-list
exit
interface type number
no keepalive
exit
connect
Cisco IAD2430 Series Integrated Access Devices Software Configuration Guide
Purpose
Enters privileged EXEC mode.
Enters global configuration mode.
Configures a list of time slots for creating clear channel
groups (pass-through) for time-division multiplexing
(TDM) cross-connect.
When configuring cross-connect for data traffic only, do
not specify the type option.
Exits to global controller mode.
Configures the serial interface.
Sets the no keepalive function.
Configuring T1/E1 Interfaces
3-19
Hide quick links:
Advertisement
Table of Contents
