Table of Contents
Advertisement
Chapter
Chapter :
Installaton
Physical Installation
There are three ways to place the Router. The first way is to
place it horizontally on a surface, so it sits on its four rubber
feet. The second way is to stand the Router vertically on a
surface. The third way is to mount it on a wall.
Horizontal Placement
The Router has four rubber feet on its bottom panel. Set
the Router on a flat surface near an electrical outlet.
WARNING:
Do not place excessive weight
on top of the Router; too much weight could
damage it.
Vertical Placement
1.
Line up the edges of the Router with the two stands.
2.
Insert the Router into the stands.
3.
Set the Router on a flat surface near an electrical
outlet.
4-Port SSL/IPSec VPN Router
Wall-Mounting Placement
The Router has two wall-mount slots on its bottom. The
distance between the two slots is 64.4 mm (2.535 inches).
Two screws are needed to mount the Router.
Suggested Mountng Hardware
5.0-6.0 mm
1.6-2.0 mm
Note: Mounting hardware illustrations are not
†
true to scale.
NOTE:
Linksys is not responsible for damages
incurred by insecure wall-mounting hardware.
Follow these instructions:
1.
Determine where you want to mount the Router. Make
sure that the wall you use is smooth, flat, dry, and
sturdy. Also make sure the location is within reach of
an electrical outlet.
2.
Drill two holes into the wall. Make sure the holes are
64.4 mm (2.535 inches) apart.
3.
Insert a screw into each hole and leave 5 mm
(0.2 inches) of its head exposed.
4.
Maneuver the Router so the wall-mount slots line up
with the two screws.
5.
Place the wall-mount slots over the screws and slide
the Router down until the screws fit snugly into the
wall-mount slots.
64.4 mm
Print this page at 100% size. Cut along
the dotted line, and place on the wall
to drill precise spacing.
Wall Mounting Template
Installation
4
Advertisement
Table of Contents
Troubleshooting
