Table of Contents
Advertisement
1.3
Compatible Products
The chart below lists the products available from Silent Knight for use with the IFP-50.
Type of
Model
Device
IDP
See Section 5.1 for a list of compatible devices.
Addressable
SLC Devices
Hochiki
See Section 5.2 for a list of compatible devices.
Addressable
SLC Devices
5824 Serial/Parallel Printer
Interface Module
RPS-1000
5496 Intelligent Power
Module
RA-100 and RA-100R
Remote Fire Alarm
Annunciator
RA-1000 and RA-1000R
Remote Fire Alarm
Annunciator
Other
5860 and 5860R Remote
Modules
Fire Alarm Annunciator
RA-100TG and
RA-100TR Trim Ring Kit
5860TG and 5860TR Trim
Ring Kit
5865-3 and 5865-4 LED
Annunciator
5880 LED Driver Module
5883 General Purpose
Relay Module
7860 Telephone Cord
5650/5651
Silent Knight Software
Suite (SKSS)
Software
5670 SKSS Facility
Management Software
7628
Misc.
DF-50
Note: 5865-3, 5865-4, and 5880 can be used in any combination, up to a total of eight devices on one panel.
The following modems have been tested by Silent Knight for compatibility with the IFP-50
and the Silent Knight Software Suite software packages:
151302
Allows a printer to be attached for the system for on-site event logging, detector
status and event history reports. Two maximum per system.
Provides additional power, six Flexput circuits, and two Form C relays. Max 8 per
system. See RPS-1000 Installation Manual (PN 151153) for more information.
Provides 4 additional Notification Appliance Circuits/Auxiliary power. (Up to 8 per
IFP-50 system.)
Same operation, similar appearance to the on-board annunciator. Up to 8 RA-100s
and RA-1000s in any combination per system. RA-100 is gray; RA-100R is red.
Remote annunciator without a door access. Requires a fireman's key or access code to
silence or reset. Up to 8 RA-100s and RA-1000s in any combination per system.
RA-1000 is gray; RA-1000R is red.
Same operation, similar appearance as the on-board annunciator. Up to 8 5860s per
system. 5860 is gray; 5860R is red.
Trim ring kits for surface mounting the RA-100/RA-100R annunciator.
RA-100TG is gray; RA-100TR is red.
Trim ring kits for surface mounting the 5860/5860R annunciator.
5860TG is gray; 5860TR is red.
LED annunciator can display up to 30 LEDs (15 red and 15 yellow). 5865-4 has key
switches for silence and reset, and a system trouble LED.
Driver for up to 40 LEDs. Interfaces with customized annunciator boards. In addition
the 5880 has eight generic switch input points.
Provides 10 Form C relays. Designed to be driven by the 5880. Up to four, 5883s can
be used with each 5880 module.
RJ31X cord for connecting phone line to the IFP-50.
For communication and panel programming with a Windows-based computer and
modem (not sold by Silent Knight, see Table 1-1 for compatible modems). Enables
remote viewing of detector status and event history.
For remote viewing of detector status and event history. Requires a modem (not sold
by Silent Knight).
UL Listed End-of-line resistor
Dead Front insert
Table 1-1: Compatible Modems
Manufacturer
US Robotics
Description
Model
28.8
Introduction
1-3
Advertisement
Table of Contents
Troubleshooting
