Advertisement
Quick Links
XM ANTENNA
Owner's Manual
AN-90XM
PIONEER CORPORATION
4-1, MEGURO 1-CHOME, MEGURO-KU, TOKYO 153-8654, JAPAN
PIONEER ELECTRONICS (USA) INC.
P.O. Box 1760, Long Beach, California 90801, U.S.A.
TEL: (800) 421-1404
PIONEER EUROPE NV
Haven 1087, Keetberglaan 1, B-9120 Melsele, Belgium
TEL: (0) 3/570.05.11
PIONEER ELECTRONICS AUSTRALIA PTY. LTD.
178-184 Boundary Road, Braeside, Victoria 3195, Australia
TEL: (03) 9586-6300
PIONEER ELECTRONICS OF CANADA, INC.
300 Allstate Parkway, Markham, Ontario L3R OP2, Canada
TEL: (905) 479-4411
PIONEER ELECTRONICS DE MEXICO, S.A. de C.V.
San Lorenzo 1009 3er. Piso Desp. 302
Col. Del Valle Mexico, D.F. C.P. 03100
TEL: 5-688-52-90
<KYMFX/01G00000>
Published by Pioneer Corporation.
Copyright © 2001 by Pioneer Corporation.
All rights reserved.
Publication de Pioneer Corporation.
Copyright © 2001 Pioneer Corporation.
Tous droits de reproduction et de traduction
réservés.
Printed in Japan
<CZR3081-A> UC
Installation
Note:
• Before finally installing the unit, connect the
wiring temporarily, making sure it is all connected
up properly, and the unit and the system work
properly.
• Use only the parts included with the unit to ensure
proper installation. The use of unauthorized parts
can cause malfunctions.
• Consult with your nearest dealer if installation
requires the drilling of holes or other modifications
to the vehicle.
• Install the unit where it does not get in the driver's
way and cannot injure the passenger if there is a
sudden stop, like an emergency stop.
• Install the antenna on as flat a place as possible.
• Do not paint the antenna, as this may affect its per-
formance.
• Do not remove the rubber sheet from the antenna
bracket.
• Do not place things such as magnetic cards close
to the antenna because its magnet is strong.
• The antenna may be less sensitive when it is snow-
ing.
• When installing the antenna with the antenna
bracket, be careful to tighten the screws firmly.
After installing, recheck every once in a while that
all screws are tight.
• When installing the antenna with magnet, be care-
ful not to scratch the vehicle body.
• When you use the antenna installed with magnet,
detach the antenna and put it inside the vehicle
every time before entering a car wash system. If it
is left on the outside it may be knocked off and
scratch the vehicle body.
Advertisement
Related Manuals for Pioneer 90XM - AN - Satellite Radio Antenna
Summary of Contents for Pioneer 90XM - AN - Satellite Radio Antenna
- Page 1 • Install the unit where it does not get in the driver’s • When you use the antenna installed with magnet, way and cannot injure the passenger if there is a detach the antenna and put it inside the vehicle sudden stop, like an emergency stop.
- Page 2 1. Install the antenna bracket. (Fig. 2) Route the antenna cable (Fig. 4) Waterproof pad Antenna bracket Clamper Screw (A) Loosen so that rain water cannot enter. Hexagonal wrench Fig. 4 Note: • Secure the antenna cable with the supplied clamper where required. Fig. 2...
- Page 3 Do not route wiring in places that get hot, such as near the heater outlet. If the insulation of the wiring melts or gets torn, there is a danger of the wiring short-circuiting to the vehicle body. Antenna Input...
- Page 4 Specifications Power source (Provided by the satellite line) ......4.7 V DC (3.6 – 5.5 V allowable) Max. current consumption ........0.1 A Type ..............Active type Dimensions Base ......79 (W) 102 (H) 93 (D) mm [3-1/8 (W) 4 (H) 3-5/8 (D) in] Cord ..............