Table of Contents
Advertisement
Replacing the Drive Belt
If drive belt becomes worn, oil-soaked, excessively
cracked, frayed, or otherwise damaged, replace the belt.
1. Remove the drive belt cover by removing the 3 bolts
as shown in Figure 35.
1. Drive belt cover
2. Bolt (3)
3. Rotor pulley bolt
4. Curved washer
5. Rotor pulley
2. Unhook the brake spring from the idler arm to
release the belt tension (Figure 35).
3. Remove the screw and curved washer that holds the
rotor pulley (Figure 35).
4. Remove the rotor pulley and the drive belt
(Figure 35).
5. Install the new drive belt, routing it as shown in
(Figure 36).
1. Brake spring (install on
idler arm here)
2. Idler pulley
Note: Route the new drive belt first around the
engine pulley, then the idler pulley, and finally around
Figure 35
6. Drive belt
7. Rotor shaft
8. Brake spring (unhook from
idler arm here)
9. Idler pulley
10. Engine pulley
Figure 36
3. Engine pulley
4. Rotor pulley
the loose rotor pulley positioned just above the rotor
shaft (Figure 35).
6. Install the rotor pulley onto the rotor shaft
(Figure 35).
7. Install the curved washer and the rotor pulley bolt
and tighten them securely (Figure 35).
Note: The concave side of the curved washer goes
against the outside of the pulley.
8. Install the brake spring onto the idler arm (Figure 36).
9. Install the drive belt cover with the bolts you
removed in step 1.
Note: Ensure that the drive belt is properly adjusted
and operating; refer to Checking the Control Cable
and Adjusting the Control Cable.
Adjusting the Quick Shoot™
Control
If there is more than 1/2 inch (13 mm) of slack in the
Quick Shoot cable (Figure 37) or the discharge chute
does not rotate left and right in equal angles, adjust the
Quick Shoot control cables.
1. 1/2 inch (13 mm) maximum slack
1. Loosen the two Quick Shoot control cable clamps
(Figure 38).
17
Figure 37
Advertisement
Table of Contents
