Table of Contents
Advertisement
Pre-Maintenance
Procedures
Raising the Seat
Ensure that the parking brake is engaged. Lift the
seat forward.
You can access following components by raising the
seat:
•
Serial plate
•
Service decal
•
Seat-adjustment bolts (if applicable)
•
Fuel filter
•
Battery and battery cables
Releasing the Mower-Deck
Curtain
Loosen the 2 bottom bolts of the curtain to access the
top of the mower deck
Figure 33
1. Bottom bolt
Note:
Always tighten the bolts to connect the curtain
after maintenance.
(Figure
33).
2. Curtain
Lubrication
Greasing the Bearings
Service Interval: Every 25 hours—Grease all the
Grease Type: No. 2 lithium grease
1.
Park the machine on a level surface, disengage
the blade-control switch, and engage the parking
brake; refer to
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Clean the grease fittings
35) with a rag.
Note:
Scrape any paint off the front of the
fitting(s).
1. Front caster tire
g027794
Located on the seat-pan underside
1. Read the instructions
before servicing or
performing maintenance
2. Check the tire pressure
every 25 operating hours
4.
Connect a grease gun to each fitting
and
Figure
5.
Pump grease into the fittings until grease begins
to ooze out of the bearings.
6.
Wipe up any excess grease.
34
lubrication points.
Park Position (page
(Figure 34
Figure 34
Figure 35
3. Grease every 25 operating
hours
4. Engine
35).
13).
and
Figure
g032432
decal106-8717
(Figure 34
Advertisement
Table of Contents
