Advertisement
Quick Links
Seat Kit
Greensmaster
Model No. 04508
Model No. 04729
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
1
Preparing the Machine
No Parts Required
Procedure
•
If you are installing seat Model No. 04508 onto
model year 2018 or older traction units, you must
first install kit Model No. 139-6479.
•
If you are installing this kit on a new, diesel or
eTriflex traction unit without a seat, remove the 2
carriage bolts, 2 flange bolts, and 4 nuts securing
the shipping bracket to the seat pan and armrest
(Figure
1). Discard the shipping bracket and seat
pan fasteners. Save the armrest fasteners.
Important:
Ensure that you support the
armrest after removing it so that it does not
crimp or hang by the cables and wires.
© 2019—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
3000 Series TriFlex
Description
No parts required
Seat assembly
Flange nut
Short wire harness
Cable tie
Register at www.Toro.com.
®
or eTriFlex Traction Unit
Qty.
–
Prepare the machine.
1
4
Install the new seat.
1
2
Figure 1
1. Armrest
2. Shipping bracket (discard)
3. Flange bolt (save)
Original Instructions (EN)
All Rights Reserved *3431-480* A
Printed in the USA
Form No. 3431-480 Rev A
Installation Instructions
Use
4. Seat pan
5. Carriage bolt (discard)
g277118
Advertisement
Related Manuals for Toro 04508
Summary of Contents for Toro 04508
- Page 1 Short wire harness Cable tie Preparing the Machine No Parts Required Procedure • If you are installing seat Model No. 04508 onto g277118 Figure 1 model year 2018 or older traction units, you must first install kit Model No. 139-6479. 1. Armrest 4.
- Page 2 • If you are installing a premium seat on a traction unit with a standard seat installed, complete the following procedure: Park the machine on level ground, shut off Installing the New Seat the engine (if equipped), engage the parking brake, and remove the ignition key.
- Page 3 Note: The eTriflex does not have holes in the Route the console wire harness between the seat pan; if you want to adjust the seat, change seat bracket and the seat slide (Figure the position of the seat on the seat mount brackets as shown in Figure g278221...
-
Page 4: Operation
Operation Install the armrest to the seat using the 2 flange bolts and flange nuts that you removed previously (Figure Seat Controls Seat-Adjusting Lever The seat-adjusting lever is located on the front, left corner of the seat (Figure 9). Twisting the handle up allows you to adjust the seat forward and rearward. - Page 5 Weight-Adjustment Lever Models 04729 You can adjust the seat for your weight to provide a smooth and comfortable ride. Important: To adjust the seat, the driver must be seated. Adjust the seat for your weight by pulling out the lever and then pumping it up to increase the suspension or down to decrease it (Figure...
- Page 6 Lumbar Support Knob Backrest Locking Lever Models 04729 Models 04729 The lumbar support increases both the seating comfort You can adjust the back of the seat to provide a more and a customized lumbar support for your lower back. comfortable ride. Turn the adjustment knob upward to adjust the Pull up the locking lever to release the backrest catch curvature in the upper part of the backrest cushion.
- Page 7 Notes:...